SCR H-TAG-LD SPECIFICATIONS [CONFIDENTIAL] Meir D. Ver 0.
Version History: 0.10 0.11 0.12 0.13 Initial version Add mechanical dimensions & target market Minor names fixes Products names update + add HR-TAG-LD Contents 1. Global system specifications ................................................................................................... 4 1.1 1.2 2 System components ........................................................................................................ 4 TAG/IDU/BU communication overview ............................................
H-TAG-LD FCC ID: AMUHTAGLD Manufacturer: SCR Engineers Ltd. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. The FCC Wants You to know NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
1. Global system specifications All units are for outdoor use, required Radio regulations according to target market & Low voltage 24VDC regulation (except for tags which powered by internal battery). Target market 1.
1.
2 H-TAG-LD Specifications 2.1 General description Tag is a unit mounted on a collar on the animal neck, used for the following: 1. Identification of animal using 2.4GhZ and/or optical unit. 2. Measure various animal parameters, Process then and transmit them via 2.4GhZ. The tag initiates transmission of 3 messages/hour by itself or upon request from ID unit. Outdoor installation, sealed unit, powered from internal 3.6V battery. 2.2 2.
2.
2.5 Block diagram Tag Block diagram Debug LED Photodiode PCB Antenna IRDA Receiver RF Transceiver uC Activity Sensor 3.6V Battery LDO 2.2V Supply 3 Environmental Conditions 1. IP – required IP68. 2. Operational temperature -33°C to 50°C. 3. Storage – TBD 4. Transportation Complies with ETS 300 019 -2-2 T2.3 Complies with ETS 300 019 -2-1 T 1.
4 Installing the tag It is important to correctly attach the tags to the cow's neck in a secure manner in order to avoid them from turning or falling off. To securely attach the tag to the cow’s neck: 1. Ensure that your tag assembly kit includes the following parts: i. H-Tag ii. Belt, Weight & Buckle 2. Open the outside locker of buckle using the buckle opener (supplied with each system) or a large flat screwdriver. 3.