SCR HR-TAG-LD SPECIFICATIONS [CONFIDENTIAL] Meir D. Ver 0.
HR_TAG_LD SPECIFICATIONS 2 Ver 0.13 Version History: 0.10 0.11 0.12 0.13 Initial version Add mechanical dimensions & target market Minor names fixes Products names update Contents 1. Global system specifications ............................................................................................................................................... 4 1.1. Target market .................................................................................................................................
HR_TAG_LD SPECIFICATIONS 3 Ver 0.13 HR-TAG-LD FCC ID: AMUHRTAGLD Manufacturer: SCR Engineers Ltd. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
HR_TAG_LD SPECIFICATIONS 4 1. Ver 0.13 Global system specifications All units are for outdoor use, required radio regulations according to target market & Low voltage 24VDC regulation (except for tags which powered by internal battery). 1.1.
HR_TAG_LD SPECIFICATIONS 5 2. HR-TAG-LD Specifications 2.1. General description Tag is a unit mounted on a collar on the animal neck, used for the following: 1. Identification of animal using 2.4Ghz and/or optical unit. 2. Measure various animal parameters, Process then and transmit them via 2.4Ghz. The tag initiates transmission of 3 messages/hour by itself or upon request from ID unit. Outdoor installation, sealed unit, powered from internal 3.6V battery. 2.2. 2.
HR_TAG_LD SPECIFICATIONS 6 Ver 0.13 2.5 Block diagram Tag Block diagram Debug LED Photodiode PCB Antenna IRDA Receiver uC RF Transceiver Activity Sensor 3.6V Battery LDO 2.6 Environmental Conditions 1. IP – required IP68. 2. Operational temperature -33°C to 50°C. 3. Storage - TBD 4. Transportation Complies with ETS 300 019 -2-2 T2.3 Complies with ETS 300 019 -2-1 T 1.2 6 2.
HR_TAG_LD SPECIFICATIONS 7 Ver 0.13 3. Installing the tag It is important to correctly attach the tags to the cow's neck in a secure manner in order to avoid them from turning or falling off. To securely attach the tag to the cow’s neck: 1. Ensure that your tag assembly kit includes the following parts: i. H-Tag ii. Belt, Weight & Buckle 2. Open the outside locker of buckle using the buckle opener (supplied with each system) or a large flat screwdriver. 3.