Instruction manual

ManualsBrandsSCOTT Manualsaudio & home theatreCX 82 Sola

Instruction Manual

Dual Alarm Clock Radio with

Digital Display

CX 82

PACKAGE INCLUDES:

1. The unit 2. Instruction manual

LOCATION OF CONTROLS

234

6 7

91012

1. ALARM/SLEEP OFF button

2. ALARM button

3. TIME button

4. SNOOZE button

5. FAST button

6. SLOW button

7. SLEEP button

8. ALARM 1/1+2/2 switch

9. TUNING knob

10. LED display

11. VOLUME/OFF BUZZER knob

12. ON/OFF/AUTO switch

13. Clock back up battery cover

14. FM antenna wire and AC power cord

INSTALLING BATTERIES

Installing the clock back up battery

Clock back up

The clock and alarm time can be maintained during a power failure with a 9V “6F22” battery (not

supplied). During power failures, the clock time may gain or lose a few minutes per hour and may

require resetting.

Battery insertion

1. Remove the battery cover on the bottom of the unit, by pressing the top edge.

2. Insert a 9V “6F22” battery (an alkaline battery is recommended) into the battery compartment,

following the correct polarities marked inside the battery compartment.

3. Replace the battery cover.

Note: For optimum performance, the battery should be replaced every 6 months.

Precautions when using batteries

1. Use only the size and type of battery specied.

2. Ensure you follow the correct polarities when installing the battery, as indicated in the battery

compartment. A reversed battery may damage the unit.

3. An exhausted battery must be removed to prevent possible battery leakage.

4. Dispose of batteries properly according to environmental regulations.

Notes on clock back up battery

Please note that this unit will not operate fully by battery power alone. The battery provides a back up

system only in the event of an interruption of the AC power supply.

GB-1

CR38 SCOTT CX82 GB IM.indd 1 7/13/2009 5:34:59 PM

Summary of content (4 pages)

PAGE 1
CX 82 Dual Alarm Clock Radio with Digital Display Instruction Manual PACKAGE INCLUDES: 1. The unit 2. Instruction manual LOCATION OF CONTROLS 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14.
PAGE 2
PRECAUTIONS Follow the advice below for safe and appropriate operations. INSTALLATION • Do not use the unit in places which are extremely hot, cold, dusty, or humid. • Place the unit on a flat and even surface. • Do not restrict the airflow of the unit by placing it in a place with poor airflow, by covering it with a cloth, or by placing it on a carpet. SAFETY • When connecting and disconnecting the AC power cord from the AC mains outlet, pull the plug and not the cord itself.
PAGE 3
OPERATING INSTRUCTIONS Connecting the power supply Insert the AC power cord into the AC mains outlet with a 230V AC ~ 50Hz power source. The LED display will flash. Clock setting 1. Press and hold down the TIME and FAST buttons to set the clock quickly. 2. Press and hold down the TIME button and press the SLOW button repeatedly to set the clock precisely, minute by minute. Alarm operation The unit allows you to wake up to the buzzer or radio. Set the alarm time 1 1. Adjust the ON/OFF/AUTO switch to AUTO.
PAGE 4
Sleep function This function allows you to program the radio to turn off automatically after a certain amount of time (up to 59 minutes). 1. In OFF/AUTO mode, press and hold down the SLEEP button, and “0:59” is displayed. The radio turns on. Note: The sleep function does not work when the ON/OFF/AUTO switch is in the ON position. 2. Hold down the SLEEP button and press the FAST or SLOW button to adjust the minutes quickly or precisely from 59 to 0 minutes). 3.