User's Manual

MAGNETIC CONTACT TRANSMITTER

INTRODUCTION

The TX-3DS is a fully supervised magnetic contact transmitter. With a built-in reed

switch it can be used to secure doors and windows.

Fig.3

Fig.5

Hole to reach TEST

button inside

Transmission

LED

Magnet

Location

Mark

Fig. 1

LED

JP3

Test Button

Tamper

Switch

Aux. Input

Terminals

Fig.2

Reed

Sensor

Wiring Inlet

Fig. 4

JP3-DIS: No “CLOSE” signal is sent

when the door/window is

closed.

EN: Sends “CLOSE” signal when

the door/window is closed.

PAGE 1
MAGNETIC CONTACT TRANSMITTER INTRODUCTION The TX-3DS is a fully supervised magnetic contact transmitter. With a built-in reed switch it can be used to secure doors and windows. Hole to reach TEST button inside Test Button LED Transmission LED Reed Sensor JP3 Tamper Switch Magnet Location Mark Fig. 1 Aux. Input Terminals Fig.2 JP3-DIS: No “CLOSE” signal is sent when the door/window is closed. EN: Sends “CLOSE” signal when the door/window is closed. Fig.3 Wiring Inlet Fig. 4 Fig.
PAGE 2
INSTALLATION A. Enrolling Code 1. Loosen the screw of the TX-3DS, then open the upper case and insert two AAA alkaline batteries. Important Notice: In order to reset the microprocessor properly before changing the batteries, please press TEST button for 5 seconds to discharge the energy that remains in the capacitors of TX-3DS. Otherwise, it may not restart after changing batteries. 2. Select “Installer Mode” on the Base Unit, and enter Installer Password to gain access authority. Then select \Set Device\E
PAGE 3
SPECIFICATIONS Supervision: sends heartbeat signal at 60-minute interval. When Tamper or Low Battery condition is detected, it reports automatically. Power Source: two AAA alkaline batteries. Current Drain: 5uA @ standby, 20mA @ operation Estimated Battery Life: 3 years (@ actuated 10 times/day) Transmitter Size: 20 x 29 x 123.
PAGE 4
Manual-BackCover.