User's Manual

REMOTE CONTROLLER

INTRODUCTION

RC-3 is a remote controller, which controls LS-30 Base Unit remotely. Thanks to

using hopping-code technology, it is highly secure.

There are four buttons on RC-3, as shown below

Disarm: To disarm the system.

Away: To arm the system.

Home: To arm the system partially. Burglar sensors with Inactive Home

Mode attribute are disabled.

Panic: To activate panic alarm.

INSTALLATION

Select “Installer Mode” on the Base Unit, and enter Installer Password to gain

access authority. Then select \Set Device\Enroll Device\Controller\Enter Zone No.

to enroll the ID of RC-3 by pressing its DISARM button. You may change its

various attributes under \Set Device\Change Device Setting\Controller Change, to

fulfill different requirements.

Remarks: If an RC-3 is set with Latchkey attribute ON, the Base Unit will call

“Latchkey Number” (refer to section 4-2-1) whenever the Disarm or

Away button is pressed.

SPECIFICATIONS:

Buttons: 4

Radio Code: hopping, with 7.3 X 10

combinations.

Battery: CR2032 button cell, 3V

Estimated Battery Life: 4 years (@actuated 4 times / day)

Size: 40.5 x 55.0 x 12.7 mm

Weight (w/ battery, w/o key ring): about 18g

Disarm

Home

Away

Panic