Instruction Manual Model XT512 Hz Sonde / Camera Locator Manufactured By Schonstedt Instrument Company 100 Edmond Road Kearneysville, WV 25430 (304) 725-1050 Fax (304) 725-1095 Made in USA Preface The Model XT512 Sonde / Camera Locator is a product of over fifty years experience in producing the world's finest magnetometers, magnetic detectors, sonde and pipe/cable locators, for a wide range of commercial and military applications.
Table of Contents SECTION I: GENERAL Introduction Control Buttons LCD Display Alternate Directional Indication Page 3 3 4 5 SECTION II: SPECIFICATIONS Common Sonde/Camera Locator Passive (60/50 Hz) Cable Locator 6 6 6 SECTION III: OPERATION Sonde/Camera Locator Passive (60/50 Hz) Cable Locator Standard Accessories Optional Accessories 7 7 8 8 SECTION IV: BATTERY INSTALLATION 9 SECTION V: TECHNICAL SUPPORT 10 SECTION VI: WARRANTY / SERVICE INFORMATION 11 Important Notice Schonstedt believes the s
SECTION I: GENERAL Introduction The XT512 default operation mode is the "sonde" mode, but it can also operate in "passive" mode. In the sonde mode the receiver searches for the signal transmitted by a small sonde (or camera with a built-in transmitter) that has been routed through a pipe. The sonde must emit a 512 Hz, unmodulated signal to be able to be detected by the receiver.
LCD Display The LCD display has six general areas to display information to the user: a Battery Indicator, a Gain Indicator, a Mode Indicator, a Direction Indicator, a Numeric Display and a Volume Indicator. BATTERY INDICATOR - The "Battery" symbol indicates the receiver's battery status as follows: when all 3 segments inside the battery symbol are present, the battery is fully charged. When only 2 segments are present the battery has a medium charge. A single segment present signals a low battery.
VOLUME INDICATOR - The Volume indicator consists of a speaker symbol with 3 sound wave bars (as shown at right). If the volume is off, the speaker symbol with NO bars is shown (see below), for medium volume the speaker symbol with 2 bars is shown (see below) and for maximum volume the speaker symbol with 3 bars is shown (see below). Volume OFF Medium Volume High Volume Audio The receiver produces an audible indication of signal strength.
SECTION II: SPECIFICATIONS (Specifications are subject to change without notice) Common: Battery: 9 V Alkaline single battery Battery Life: 12 hours intermittent use Audio Output: 10 - 1400 Hz determined by signal strength 0 - 70 db SPL (Sound Pressure Level), volume controlled Weight (incl. batteries): Under 2.8 lbs Operating Temp: -4°F to 140°F (-20°C to 70°C) Overall Dimensions: Closed: 17.5 in x 3 in x 8.5 in (44 cm x 7.6 cm x 21.5 cm) Extended: 27.7 in x 3 in x 8.5 in (70 cm x 7.6 cm x 21.
SECTION III : OPERATION Sonde/Camera Locator Your XT512 receiver supports the detection of any standard 512 Hz sonde or camera in the market. This type of sonde or camera is usually attached to devices that are sent through non-metallic sewer or water pipes. The emitted magnetic field easily passes through the walls of such pipes.
Standard Accessories The accessories that are included with this instrument are: Soft padded carry bag Belt with receiver holder cup Battery Operation Manual Optional Accessories Schonstedt's 512 Hz sonde -8-
SECTION IV : BATTERY INSTALLATION The XT 512 is powered by one 9-volt battery. The battery is located in the handle of the instrument and can be accessed by turning the screw counterclockwise by hand or with the use of a screwdriver or coin. To remove the battery, simply tilt the receiver so that the handle is pointing down, and the battery will slide out. When replacing the battery, look at the inside of the battery door for the proper battery orientation.
SECTION V : TECHNICAL SUPPORT Technical Support Schonstedt offers technical support and sales. For any reason regarding usage and application please contact our technical support team at 888-32-TRACE (888-328-7223). FOR SERVICE OR REPAIR Please ship locator to: Schonstedt Instrument Company 100 Edmond Road Kearneysville, WV 25430 Attn: Repair Dept.
SECTION VI : WARRANTY INFORMATION Limited Warranty The Schonstedt Instrument Company (Schonstedt) warrants each product of its manufacture to be free from defects in material and workmanship subject to the following terms and conditions. The warranty is effective for 3 years (with the return of the Customer Registration Card) after the shipment by Schonstedt to the original purchaser.