EBIOTPCWM User Manual Version 1.1 Date Version Editor Status Notes 21.10.2022 0.1 Tuomo Nikkilä Draft Initial draft created, Electronics information added 25.10.2022 0.2 Timo Yli-Pietilä Draft Integration guidelines and labelling chapter added 26.10.2022 0.3 Ella Raitio Draft Label and compliance information added 1.11.2022 0.4 Ella Raitio Draft Certification information added 15.11.2022 0.5 Ella Raitio Draft Updated labelling instructions added 17.11.2022 1.0 Version 2.12.
Contents Acronyms and abbreviations .................................................................................................................. 3 1 Introduction .................................................................................................................................... 4 1.1 General.................................................................................................................................... 4 1.2 Certification information .............................
Acronyms and abbreviations EMC Electromagnetic Compatibility SoC System on Chip IC Integrated Circuit PMN Product Marketing Name HVIN Hardware Version Identification Number © Schneider Electric Buildings LLC (Authored by Treon Oy for Schneider Electric) Page 3|9
1 Introduction 1.1 General EBIOTPCWM (also referred to as ,,TR Module’’ to increase the readability of this document) is a BLE/Wirepas 2.4GHz radio module. In general, TR Module includes full 2.4 GHz radio functionality including radio SoC (System on Chip), power supply, crystals, antenna, and interface for variety of sensor modules. TR Module is not sold separately, it is part of selected commercial products. 1.
2 Operating conditions The operating conditions of EBIOTPCWM can be found in the table below. Operating voltage V Operating temperature C Current consumption Min 1.7 0 10uA Max 3.6 50 20mA Maximum clock frequency is 32MHz and sleep clock is 32kHz. 3 Integration instructions for host product manufacturers 3.1 List of applicable FCC / ISED rules FCC: 47 CFR Part 15 Subpart C §15.247 ISED: RSS-247, Issue 2 3.
RF Exposure Evaluation with SAR exclusion for TR Module (IoT Desk Occupancy Sensor Solution used as a test jig) is available. In SAR calculations 5mm separation distance was used giving results well below the limits. 3.6 Antennas TR Module contains integrated monopole PCB trace antenna. TR Module’s internal antenna peak gain is 4.8dBi. More details are available in separate antenna report (document name Antenna report for Desk and IAQ sensors). 3.
4.1 Labelling instructions The host product shall always be labelled with the FCC ID and the IC ID of the radio module, regardless of whether the module is visible in the host product or not, because due to the small size of the TR Module, the IDs cannot be shown on the module itself. Below examples are shown how the information should be presented in the labelling of the end-product(s) and also how to place the label(s) to prominent location(s) on the end-product(s).
Figure 3. Label placement example of the end-product EBIOTPCWD. Figure 4. Label placement example of the end-product EBIOTPCWE1.
5 FCC and ISED statements FCC This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications made to the device not expressly approved by the party responsible for compliance may void the user’s authority to operate the equipment.
