LOCK SETUP Follow these steps to get your lock sat up and ready fo use. If you would like to use a home automation system, refer to Z-wave Functions on gaps 10. 1 Decide what length you want the User Codes for the lock to be. You can set User Codes to be from 4 8 digits in length. The default length is 4 digits. All User Codes must be the same length. Any time you change the User Code length, all current User Codes will be deleted from the lock. « See Change User Code Length on page 8.
REPLACING THE BATTERIES 3% Replace the batteries in your lock at the same time each year that you test and replace the batteries in your smoke alarms. This wil ensure continued reliable operation. 3% Use four high-quality alkaline AA batteries for replacement. Lithium baptisteries may cause undesirable operation. ELECTROSTATIC DISCHARGE WARNING! I’ DO NOT TOUCH the circuit board! You may damage the lock. 2. Unsnap the battery connector, 3.
CLEANING THE LOCK in larder to properly clean the touchscreen from build-up of dirt, oils, or other contaminates; you should ues a mild dish soap with warm water and follow the general rules below: = Dao rinse the touchscreen with warm water prior to cleaning processes. « Do follow the application of soap with a damp, lukewarm cloth, = Don't use abrasives, high alkaline cleaners, or gasoline. « Don't leave cleansers on touchscreen for long periods, wash immediately.
PROGRAMMING PROCEDURES $9 Determine how long you want your User Codes to be BEFORE 1. Open the door and extend the deadbolt before beginning. adding any User Codes. If you change the User Code length, all 5 make 8 mistake, press the Scrimmage Button to leave existing User Odes wil be deleted] Programming Moro, snd then star over v $b Programming Mode will automatically me out after 30 seconds of inactivity.
ENABLE/DISABLE AUTO-LOCK Enter Sigh v Enables | Ink | asp Disable: blinks + seeps | Within § seconds, manually ck and unlock the deadbolt vv using the thumb tum, 1 Bill: 1B * Dion shiatsu be locked to begin RESTORE AUTO-LOCK Frost pools the deadbolt using Vv the miniaturist, MY CODES Usa the table on page 8 to record Programming and User Cedes that you program into the lock.
FACTORY DEFAULT RESET When should you perform a Factory Default Resat? « If you want to move the lock to a different door, you need to restore default settings, move the lock to the new door, and then set up the lock again. « if you java forgotten your Programming Cods, you can rosters the default codes. 1. Disconnect the batteries. Ses Replacing the Batteries on page NOT Te 4 Locate the default Programming and User Codes on the back of 2. Press and hold the Scrimmage Button.
Z-WAVE FUNCTIONS About Z-Wave This lock iz a Security Enabled Z-Wave Product. « This lock may be included into Z-Wave networks from various manufacturers. « Listening nodes from any manufacturer can act as repeaters to extend network range. = The lock will have limited functionality if included with a non-secure controller. « Configuration parameters and association group information can be found at answers.schiage.com.
TROUBLESHOOTING { forget my Programming Code. Check the back of the Interior Assembly for default Programming Coda. -— — if needed, restore lock to factory stings. See Factory Default Reset on page a. i nea to deists a User Cods that | Valets ail User Codes. Then add all needed User Codes back inch the look. See don't remember. Programming the Touchscreen on page 5. Cannot add a new User Gods. Yalow dot 1 was not pressed after entering Programming Mads. fishing 30 User Codes already exist.