User Manual

The VIP993 series lock is a microprocessor controlled,
electromechanical locking system which bolts on to new
or existing Von Duprin 98 & 99 rim and vertical rod exit
devices. It is an open architecture product designed to
interface with 3rd party access control panels encom-
passing all the features of the lock, reader, door status
and egress (rex/request to exit) indication in one piece
of hardware. It is powered by 12 or 24 volts DC with
only four wires required to the door - two for power and
two for communications. For door status indication a
door switch (included) must be installed. For request to
exit (REX) the Von Duprin exit device must be equipped
with the exit indication switch (order a RX-LC98/99 exit
device or Von Duprin P/N S1-LC for an aftermarket application)
and a pair of wires (included) must be run from the switch
to the VIP993. The lock communicates with a PIB (panel
interface board) which communicates with the panel as if it
were separate components of an access control system.
Operationally, the outside lever is normally locked the exit
device allows free egress. Electronic access control is
achieved by entering an”Access Credential” (magnetic
stripe card or Prox fob or card). The panel controls the lock
through the PIB.
Compatible Von Duprin exit device
models include:
98/99
9827/9927
9847/8847
9848/9948
9857/9957
Form 61997 Rev. A
01-05-20041
VIP993 OPEN ARCHITECTURE TRIM
HARD-WIRED INSTALLATION MANUAL
MG-FSA
MG-FSE
PX-FSA
PX-FSE
PIB
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device
may not cause harmful interference, and (2) this device must accept any interference received, including any interference
that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for com-
pliance could void the user’s authority to operate the equipment.