User's Manual

User manual

Introduction

Congratulations on receiving your SR-3. As part of our Green Initiative, we do not include printed user

documentation with our product packaging. This policy saves paper, lowers shipping costs, reduces carbon

emissions and results in a cleaner environment.

Documentation

All product and accessory documentation can be found at the GLI Support Centre: http://www.gl-inet.com/docsOn

this site you will gain access to GLI technical resources and information about GLI products. To use your new GLI

Mini Router you will need to follow the simple steps which you can see from

http://www.gl-inet.com/docs/wiki/#!mini/index.md

Default System Settings

Product

LAN Default IP Address

LAN Fall-back IP Address

750M Travel AC Router

DHCP

192.168.8.1

Initial Set-up

Interfaces described as followed:

Power to the GLI Mini Router is provided by connect the power lead (supplied) to the power adaptor (buy

separately) and then to the power interface on the GLI Mini Router.

Once power is provided to the GLI Mini Router the LED’s will provide status on its operation based on the

following:

LED

Indicator

Description

LED 1 (Power)

Green solid

Power is applied

LED 2 (Customized)

Customized

This is customized LED.

LED 3 (WiFi connection)

Red

Indicates WiFi signal (solid) and

data transfer (flashing).

Button Definition

 Press the Reset button to toggle the WiFi signal ON or OFF.

 Press and hold the Reset button for at least 8 seconds, then release your finger to reset the router to factory

default state. Wait until the router reboots, which could take about 3 minutes.

PAGE 1
User manual Introduction Congratulations on receiving your SR-3. As part of our Green Initiative, we do not include printed user documentation with our product packaging. This policy saves paper, lowers shipping costs, reduces carbon emissions and results in a cleaner environment. Documentation All product and accessory documentation can be found at the GLI Support Centre: http://www.gl-inet.com/docsOn this site you will gain access to GLI technical resources and information about GLI products.
PAGE 2
 The function of “switch” is configurable by user. FCC Statement 1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)This device may not cause harmful interference. (2)This device must accept any interference received, including interference that may cause undesired operation. 2. Changes or modifications not expressly approved by the party responsible for compliance could void the users’ authority to operate the equipment.
PAGE 3
WARNNING: The minimum separation generally be used is at least 20 cm, even if the calculations indicate that the MPE distance would be lesser. This equipment complies with FCC radiation exposure limits set forth for an u ncontrolled environment. This equipment should be installed and operated wit h minimum distance 20cm between the radiator & your body.