TV Adapter 3.
Introduction to this booklet Intended use This booklet guides you on how to use and maintain your new TV Adapter. Please read the booklet carefully, including the Warning section. This will help you to get the most out of your new TV Adapter. The TV Adapter is intended as a wireless transmitter of sound from a TV or from other electronic audio devices to hearing aids. If you have additional questions about the use of your TV Adapter, please contact your hearing care professional.
Table of content About Package content TV Adapter overview 6 8 Installation Installation Placing the TV Adapter Connecting the TV Adapter to a power outlet Connecting the TV Adapter to the TV Connecting using TOSLINK Connecting using RCA Connecting using mini jack Adapter Connecting using SCART Pairing the TV Adapter with your hearing aids 10 11 12 14 16 18 20 22 24 Start TV sound using the hearing aid Remote Control Turn off TV sound using your Remote Control Volume control using your Remote Control Mu
Package content The TV Adapter box consists of the following elements: TV Adapter Power supply TOSLINK RCA cable TV Adapter 3.
TV Adapter overview Front Power Mode Power indicator Power on, not paired to any hearing aids TV indicator TV Pairing complete (steady light 30 secs) Power on, not streaming Back RCA inserted and streaming TOSLINK inserted and streaming (digital) Setup TOSLINK inserted and streaming (invalid signal)* Power supply Fault condition * No light Blinking Fading * Try other input connection ** Contact your hearing care professional 8 About Installation Daily use Steady POWER L RCA left and
Installation Placing the TV Adapter Using the TV Adapter for the first time Before you can use your hearing aids with your TV, the TV Adapter must be connected to a power outlet, connected to the TV and paired with your hearing aids. Place the TV adapter close to the TV - horizontally, with free line of sight to the hearing aids. This is a step-by-step guide on how to install the TV Adapter. All parts needed for the installation are included in the package.
Connecting the TV Adapter to a power outlet Start by connecting the TV Adapter to a power outlet. Use the power supply from box 1 1. Plug the power cord into the “power” connector on the TV Adapter (A). 2. Plug the power supply into the mains wall socket (B). 3. Check that the power is turned on; after a few seconds both indicators will fade blue to indicate that pairing with your hearing aids is needed. See page 24.
Connecting the TV Adapter to the TV TOSLINK (p. 16) You can connect the TV Adapter to the TV in four different ways. 1 Connection Audio Out 3 Page TOSLINK. Either digital stereo (PCM) or Dolby® Digital * L R 16 RCA audio output L+R 18 Mini jack audio output (typically headphone output) 20 SCART audio output (L+R) 22 Mini jack (p. 20) *Dolby and the double-D symbol are registered trademarks of Dolby Laboratories. We recommend using TOSLINK.
Connecting using TOSLINK 1. Use the TOSLINK cable from box no. 3 (A). 2. Remove the plastic cap from the TOSLINK cable. (B) 3. Connect the TOSLINK cable to the TOSLINK output on your TV/home theater system (C). 4. Connect the TOSLINK cable to the pink TOSLINK input (D) on the TV Adapter. 5. The TOSLINK output (E) may be used to connect other TOSLINK devices such as external Dolby Decoders and surround sound systems. 6. Refer to page 24 for pairing of the TV Adapter with your Hearing Aid.
Connecting using RCA B 1. Use the RCA cable from box no. 2 (A). 2. Connect the RCA cable to the RCA output on your TV (B) or home theater system. (Typically marked “L – R AUDIO OUT” and found on the TV back or bottom panel.) 3. Connect the RCA cable to the RCA connectors (C) on the back of the TV Adapter. 4. Refer to page 24 for pairing of hearing aids with the TV Adapter.
Connecting using mini jack Adapter 1. Use the mini jack Adapter from box no. 2 (A). 2. Connect the RCA cable to the mini jack Adapter (B1). 3. Connect the mini jack to the TV, this is typically the headphone output (B2). 4. Connect the RCA connectors to the TV Adapter RCA input (C). 5. Refer to page 24 for pairing of the TV Adapter with your hearing aids. Please note: The TV speakers may be muted when connecting to the headphone output, and sound only heard through the Hearing Aids/TV Adapter.
Connecting using SCART 1. Use the SCART Adapter from box no. 2 (A). 2. Connect the RCA cable to the red and white terminals on the SCART Adapter (B). 3. Connect the SCART Adapter to the SCART output on your TV (C). 4. Connect the RCA connectors to the TV Adapter RCA input (D). 5. Refer to page 24 for pairing of the TV Adapter with your Hearing Aids. B 1 Audio Out 3 L R Box 2 Please note: The audio output on the SCART connector can be dependent on the source selected on the TV.
Pairing the TV Adapter with your hearing aids Before using the TV adapter, it must be paired with your hearing aids. Pairing is only required once, and takes around 20-60 seconds. Note: This TV Adapter can be paired to as many hearing aids as you like. All users will be able to hear the same sound. Please see page 38 for more details. IMPORTANT NOTICE Please refer to your hearing aid‘s instructions for use for details on the functionality of your specific hearing aid solution.
Start TV sound using your hearing aids Turn off TV sound using your hearing aids Once a TV Adapter has been paired with your hearing aids, it will be available as a program in your hearing aids. To listen to TV simply press and hold the program switch on your hearing aids to change programs. To stop the sound from the TV simply change to the desired program in your hearing aids. The program cycle will depend on the programs already available in your hearing aids.
Volume control using your hearing aids Use the volume button on your hearing aid to adjust the TV volume level in both hearing aids. Adjust the volume by pressing up or down briefly. Press briefly repeatedly for further adjustments. A short press on the RIGHT hearing aid increases the volume. A short press on the LEFT hearing aid decreases the volume IMPORTANT NOTICE Note: The TV volume in the hearing aids is normally not affected by volume adjustments from the TV Remote Control.
Start TV sound using the hearing aid Remote Control The Remote Control is an optional accessory to your wireless hearing aids. Turn off TV sound using your Remote Control To stop the sound from the TV simply change to the desired program in your hearing aids. Once a TV Adapter has been paired to your hearing aids it will be available as a program. To listen to TV simply press the program selector and change program (A). The program cycle will depend on the programs already available in your hearing aids.
Volume control using your Remote Control Mute using your Remote Control Use the volume buttons on your remote to adjust the TV volume level in both hearing aids. While watching TV you can switch off the microphones in your hearing aids, so that only the sound from the TV is heard. Adjust the volume by pressing up or down briefly. Repeat the brief press for further adjustments. Press and hold the volume down button for approx 3 seconds until the surrounding sound is muted.
Start TV sound using the Oticon ON App Turn off TV sound using the Oticon ON App The Oticon ON App is an optional accessory to your wireless hearing aids. The app works with iPhone®, iPad®, iPod touch®, and Android™ devices. iPhone, iPad, and iPod touch are trademarks of Apple Inc., registered in the U.S. and other countries. Android is a trademark of Google Inc. For information on compatibility, please visit www.oticon.com.
Volume control using the Oticon ON App Mute using the Oticon ON App Swipe your finger up or down to adjust the volume. While watching TV you can switch off the microphones in your hearing aids, so that only the sound from the TV is heard. 0 0 P1 Press the volume indicator to mute the surrounding sounds. You will hear a confirmation beep indicating that the microphones in the hearing aids are now muted.
More than one user Removing a user/clear pairings An unlimited number of hearing aid users can listen to the sound from one TV Adapter. To remove a user from your TV Adapter perform a system reset and re-pair the required hearing aids. Pair the hearing aids to the TV Adapter as described on page 24. 1. Reset system: Press and hold the setup button for more than 5 seconds 2. Indicators fade blue to indicate no pairings 3.
Cleaning and maintenance Use a soft, dry cloth to clean the TV Adapter. IMPORTANT NOTICE The TV Adapter must never be washed or immersed in water or other liquids.
Warnings You should familiarize yourself fully with the following general warnings and the entire contents of this booklet before using your TV Adapter to ensure personal safety and correct use. Consult your hearing care professional if you experience unexpected operations or events with your TV Adapter. Choking hazards and risk of swallowing small parts • Your TV Adapter and its parts should be kept out of reach of children and anyone who might swallow these items or otherwise cause injury to themselves.
Technical information USA and Canada This device is certified under: Model name TVA3 Operating conditions Temperature: +5°C to +40°C Humidity: 15% to 93%, non-condensing Atmospheric pressure: 700 hPa to 1060 hPa FCC ID: 2ACAHTVA3 IC: 11936A-TVA3 Storage and transportation conditions Temperature and humidity shall not exceed the below limits for extended periods during transportation and storage: Temperature: -25 °C to +70 °C Humidity: 15% to 93%, non-condensing The device complies with Part 15 of t
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
Waste from electronic equipment must be handled according to local regulations. 48 About Installation SBO Hearing A/S Kongebakken 9 DK-2765 Smørum Denmark www.sbohearing.com E2831 Daily use Warnings Additionals 168366US / 06.06.2016 Declaration of Conformity is available at the manufacturer. 168366US / 06.06.2016 The manufacturer declares that this TV adapter is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC.
0000168366000001