Specifications

ManualsBrandsSBM ManualsBike ComputersSmart Bike Module

Tag360-SBM

contactus@tagbox.co

Tag360-SBM is a Bluetooth Low Energy (BLE) “Smart Bike Module” intended as an add on

attachment to vehicles, thus allowing the vehicles to be immobilised using associated Keyfob

device, TAG360-KF, or via a mobile app.

Tag360-SBM uses Bluetooth Low Energy (BLE) to get mobilize or immobilise commands from

TAG360-KF, or from mobile app. These commands are passed on to vehicle’s engine control

unit (ECU) via a digital bus, e.g. CAN. Tag360-SBM is powered by vehicle’s battery. A backup

battery of 12V is provisioned within the unit.

Features

• BLE 4.2/5.0

• Secured via Authentication and

(optional) 128b AES encryption

Applications

• Mobilise/Immobilise vehicle

• Enhanced vehicle security

• Last parked location

Summary of content (6 pages)

PAGE 1
Tag360-SBM Tag360-SBM is a Bluetooth Low Energy (BLE) “Smart Bike Module” intended as an add on attachment to vehicles, thus allowing the vehicles to be immobilised using associated Keyfob device, TAG360-KF, or via a mobile app. Tag360-SBM uses Bluetooth Low Energy (BLE) to get mobilize or immobilise commands from TAG360-KF, or from mobile app. These commands are passed on to vehicle’s engine control unit (ECU) via a digital bus, e.g. CAN. Tag360-SBM is powered by vehicle’s battery.
PAGE 2
Tag360-SBM Specifications Electrical and Radio Specifications Radio Bluetooth Low Energy, BLE 5.0 Power Vehicle 12V battery Interface Custom 1-wire interface to TCI unit Mechanical Specifications Dimensions 66.5mm*56mm*26mm Block Diagram 12V GND Tagbox contactus@tagbox.co Copyright 2019 contactus@tagbox.
PAGE 3
Tag360-SBM Connector Pinout PIN # DESCRIPTION 1 GROUND 2 NC 3 BATTERY 4 NC 5 TCI 6 IGNITION Installation Instructions Step1: The SBM unit needs to be mounted on vehicle through its special clamp, as shown in drawing below. The clamp inserts into rubber boot, thus securing the SBM unit to the vehicle. Tagbox contactus@tagbox.co Copyright 2019 contactus@tagbox.
PAGE 4
Tag360-SBM Step2: Connect the SBI connector output to TCI Unit. The SBM connector output is a 6 pole Besmak connector-Male, which connects with corresponding 6-pole female connector of TCI unit. Step 3: The SBM unit is supplied with a pre-paired Tag360-K1 Keyfob unit. The unit has identification QR code on one side, while the functional LED and button press are provided on the back Tagbox contactus@tagbox.co Copyright 2019 contactus@tagbox.
PAGE 5
Tag360-SBM After installation of SBM unit, the vehicle can be mobilised or immobilised via the keyfob unit. Step 3.1: Turning on the vehicle a. Keyfob unit should be in Bluetooth range of the vehicle. It is recommended that the keyfob should be within 5 meters from the vehicle b. Insert physical key into the vehicle and turn the key ON c. Press Keyfob button for 1 second and wait for LED to glow. Once the green LED glows, the vehicle is mobilised d.
PAGE 6
Tag360-SBM FCC WARNING NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a vehicular installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.