User's Manual

Mounting the ST-412 Tag with the MB-412 Mounting Bracket

Tools and Materials

• Marking pencil

• Drill with #30 (.129) bit

• Three rivets (provided with mounting bracket)

• Hand-held rivet gun (recommended vendor: Pencom (distributor) PH: 1-650-573-1297 Marson P/N AB4-

4CLD or Creative P/N BAS44-CE)

• One 3.6V lithium battery, size AA (provided with tag)

Savi Technology recommends using supplied rivets and recommended gun to install tag mounting bracket.

Customers use other installation methods at their own risk.

The tag mounting bracket is 5.01 inches long, 3.1 inches wide, and 1.69 inches high. The tag is 6.8 inches long, 2.8

inches wide, and 1.52 inches high.

1. Identify tag location: a flat, vertical space that can have a tag mounting bracket riveted to it. Place tags high

for good radio communication and where they are safe from impact (e.g. inside the ribs of a container). Place

tags vertically (labels upright), as shown below.

On shipping containers, Savi recommends placing tags on the container side approximately 1 foot from the

top corner of the container.

PAGE 1
Mounting the ST-412 Tag with the MB-412 Mounting Bracket Tools and Materials • Marking pencil • Drill with #30 (.129) bit • Three rivets (provided with mounting bracket) • Hand-held rivet gun (recommended vendor: Pencom (distributor) PH: 1-650-573-1297 Marson P/N AB44CLD or Creative P/N BAS44-CE) • One 3.6V lithium battery, size AA (provided with tag) Savi Technology recommends using supplied rivets and recommended gun to install tag mounting bracket.
PAGE 2
. Drill three holes using the tag mounting bracket as a template to mark holes. 3. Push rivets through tag mounting bracket and mounting surface. 4. Use hand-held rivet gun to secure tag to mounting surface. It could take up to 3 squeezes of the gun to successfully secure a rivet and sheer off excess pin. 1. Make sure the 3.6V lithium battery is installed properly in the tag (see other side). 2 Slide tag into mounting bracket (labels right-side up) until it locks in place.
PAGE 3
. Install AA 3.6V lithium battery, matching the negative (–) and positive (+) terminals to the symbols shown in the battery compartment. 2. Replace the battery cover by sliding it into place until it fits flush with the tag case. Listen for the click as it seats. Make sure that the battery cover is completely closed. You may need to open the rubber plug covering the docking port, close the battery cover, and then close the rubber plug again. 2.