Installation Manual
Installation
Turn the Power OFF and unplug the power cable before installation.
1. Remove the Cover LH
Remove the screws ( 4 positions)
2. Install the RFID Interface Board ASSY
Plug in the Interface Board and fix it on the printer
with two screws.
3. Install the RFID Module Board ASSY
①The assembly of the eight spacers is carried
out to Module BR.
②RSDRV board is fixed with four screws.
Signal cable is fixed on tie lap.
③RFID module is fixed with four screws.
④The signal cable which has come out of the
DRV board is connected to the connector (CN1)
of RFID module.
! Caution
Cover LH
1. RFID Interface Board ASSY
2. Pan Head Screw
(M3*6, SW+WL)
Spacer(L=30mm) 4pcs
Spacer(L=15mm) 4pcs
Pan Head Screw 8pcs
(M3*6, SW+WS)
Tie lap
RFID module
DRV Board
Module BR