BluBand™ Installation Guide (DRAFT INSTRUCTIONS – FEB08)
BluBand™ FCC ID: S5EBB02158 For body worn operation this device has been tested and meets the FCC RF exposure guidelines. The highest reported SAR value is: 0.0068(W/kg) FCC regulatory statement for Part 15 devices ‐ This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.
Before You Begin The BluBand™ will normally be supplied in SLEEP mode. This mode reduces power consumption to a minimum and allows the device to be stored between initial manufacture and first use for up to 6 months. The BluBand™ is activated by light and will enter normal monitoring mode by removing from its box. Once activated the BluBand™ device will operate for at least one year under normal operating conditions The BluBand™ does not have a field replaceable or rechargeable battery.
Illustration 2 Put the device round the ankle and cut the other end of the strap to fit ensuring the strap is cut along one of the guide lines marked. Insert the strap into the other side of the BluBand™ (Illustration 3) Illustration 3 Insert the second clip into the slot, lining up the clip with the two guide holes in the strap. (Illustration 4) Illustration 4 Press firmly on the clip until the clip clicks into place, sitting just below the main case of the BluBand™.
Ensure the BluBand™ is a snug fit by inserting a finger between the BluBand™ and the leg. (Illustration 6) Installation is complete.