Installation Instructions

DC POWER CEILING FAN REMOTE CONTROL MANUAL

LEARNING PROCESS

NOTE: The Hand Held Remote Control System is equipped with a learning frequency function which has code

combinations to prevent potential interference from other remote units.

Step: 1. Install the DC1.5V/AAA 2pcs batteries. Within 30 seconds of turning the

receivers AC power ON. Press the transmitter’s “LEARN” button.

Step: 2. Hold the “LEARN” button for over 5 seconds, once the receiver

has detected the frequency, the receiver will make sound, Bi Bi, twice.

This will indicate the receiver has learned the frequency that was

previously selected on the transmitter.

NOTE: After the AC power is on, do not press any other button on the transmitter

before pressing the “LEARN” button, Because doing so will cause the procedure

to fail.

After completing the steps above, you should be able to operate the ceiling fan

and light. If the fan is not responding to the transmitter, please turn the power off

to the receiver. And repeat step 1 and 2.

NOTE: Remove the batteries if not used for long periods of time to prevent

damage to the hand held remote.

FUNCTIONS OF TRANSMITTER

: Press and release instantly to turn on or off ceiling fan.

: Press and release instantly to set 1~5 fan speed

: Press for forward/reverse airflow of ceiling fan.

Installation of Transmitter Wall Mount Holder with Two screws.

To assure continued FCC compliance:

FEDERAL COMMUNICATIONS COMMISSION INTERFERENCE STATEMENT

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the

FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential

installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in

accordance with the instructions, may cause harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to

radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to

correct the interference by one or more of the following measures:

--Reorient or relocate the receiving antenna. --Increase the separation between the equipment and receiver. --Connect the

equipment into an outlet on a circuit different from that to which the receiver is connected. --Consult the dealer or an

experienced radio/TV technician for help.

CAUTION:

To assure continued FCC compliance:

Any changes or modifications not expressly approved by the grantee of this device could void the user's authority to

operate the equipment.

FCC ID

：2AQZU-18029

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device

may not cause harmful interference, and (2) this device must accept any interference received, including interference that

PAGE 1
DC POWER CEILING FAN REMOTE CONTROL MANUAL LEARNING PROCESS NOTE: The Hand Held Remote Control System is equipped with a learning frequency function which has code combinations to prevent potential interference from other remote units. Step: 1. Install the DC1.5V/AAA 2pcs batteries. Within 30 seconds of turning the receivers AC power ON. Press the transmitter’s “LEARN” button. Step: 2.
PAGE 2
may cause undesired operation. FCC Warning This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. NOTE 1: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.