Installation Instructions

DC POWER CEILING FAN WALL CONTROL MANUAL

ACTIVATING THE LEARNING PROCESS

1. After installation is complete, AC power is turned on

within 30 seconds, press and hold the LEARN button for

1~3 seconds. The receiver will make sound, Bi, once.

This will indicate the receiver has learned the ID that

was previously selected on the transmitter. Then the

wall transmitter can control the receiver.

2. If user cannot finish the setting within the 30 seconds

time frame, the main power must be turned off and

re-started again. This will reset the unit. Repeat step 1

until the LEARNING feature is activated as indicated.

LIGHT FUNCTION SELECT SWITCH

If installed energy light onto ceiling fan, please set the “light function select switch” “light function

select switch” to O position. If installed tungsten light onto ceiling fan, please set the “light function

select switch” to D position.

WALL TRANSMITTER OPERATION

Press button 1~6 to set fan speed

Press this button to turn the fan off.

Press this button to set fan wind direction up or down.

ON/OFF—Press this button and release instantly to turn on or off the light.

DIMMER—Press and hold to dim or brighten lights to the desired level and release. (Tungsten bulb

only)

When pressing remote button, the LED indicator would be on.

TRANSMITTER

PAGE 1
DC POWER CEILING FAN WALL CONTROL MANUAL ACTIVATING THE LEARNING PROCESS 1. After installation is complete, AC power is turned on within 30 seconds, press and hold the LEARN button for 1~3 seconds. The receiver will make sound, Bi, once. This will indicate the receiver has learned the ID that was previously selected on the transmitter. Then the wall transmitter can control the receiver. 2.
PAGE 2
Installing Wall Control (TRANSMITTER): Remove wall plate, disconnect and remove the toggle switch from wall junction box. Using the wire connectors, make the electrical connections to the wall control (transmitter) unit. Carefully push all connected wires inside wall switch box. Secure wall control unit with 2 screws previously removed. Face plate could be locked onto the transmitter.