Installation Instructions

DC POWER CEILING FAN REMOTE CONTROL MANUAL

LEARNING PROCESS

NOTE:

The Hand Held Remote Control System is equipped with a learning

frequency function which has code combinations to prevent potential

interference from other remote units.

Step: 1. Install the DC1.5V/AAA 2pcs batteries. Within 30 seconds of turning

the Receivers AC power ON. Press the transmitter’s “LEARN”

button.

Step: 2. Hold the “LEARN” button for over 5 seconds, once the receiver

has detected the frequency, the receiver will make sound, Bi Bi

twice. This will indicate the receiver has learned the frequency tha

was previously selected on the transmitter.

NOTE: After the AC power is on, do not press any other button on the transmitter before pressing the “LEARN”

button, Because doing so will cause the procedure to fail.

After completing the steps above, you should be able to operate the ceiling fan and light. If the fan is not responding

to the transmitter, please turn the power off to the receiver. And repeat step 1 and 2.

NOTE: Remove the batteries if not used for long periods of time to prevent damage to the hand held remote.

FUNCTIONS OF TRANSMITTER

1. FAN SPEED：

Press to increase fan speed

Press to decrease fan speed

LEDs show speed number

: Turn off ceiling fan.

Press for forward/reverse airflow of ceiling fan.

Natural breeze: Fan speed will modulate to simulate

a natural breeze.

FAN TIMER:

：

Setting up that the ceiling fan will turn off after 1 ~

hours automatically.

LEDs show number

2. LIGHT:

PAGE 1
DC POWER CEILING FAN REMOTE CONTROL MANUAL LEARNING PROCESS NOTE: The Hand Held Remote Control System is equipped with a learning frequency function which has code combinations to prevent potential interference from other remote units. Step: 1. Install the DC1.5V/AAA 2pcs batteries. Within 30 seconds of turning the Receivers AC power ON. Press the transmitter’s “LEARN” button. Step: 2.
PAGE 2
ON/OFF—Press and release instantly to turn on or off the light. Press and hold to brighten light to the desired level and release. Press and hold to dim light to the desired level and release. Installation of Transmitter Wall Mount Holder with Two screws. To assure continued FCC compliance: FEDERAL COMMUNICATIONS COMMISSION INTERFERENCE STATEMENT This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.