Installation Instructions

DC POWER CEILING FAN REMOTE CONTROL MANUAL
LEARNING PROCESS
NOTE: The Hand Held Remote Control System is equipped with a learning
frequency function which has code combinations to prevent potential
interference from other remote units.
Step: 1. Install the DC1.5V/AAA 2pcs batteries. Within 30 seconds of
turning the Receivers AC power ON. Press the transmitter’s
“LEARN” button.
Step: 2. Hold the “LEARN” button for over 5 seconds, once the receiver
has detected the frequency, the receiver will make sound, Bi Bi,
twice. This will indicate the receiver has learned the frequency that
was previously selected on the transmitter.
NOTE: After the AC power is on, do not press any other button on the
transmitter before pressing the “LEARN” button , Because doing so will
cause the procedure to fail.
After completing the steps above, you should be able to operate the ceiling
fan and light. If the fan is not responding to the transmitter, please turn the
power off to the receiver. And repeat step 1 and 2.
NOTE: Remove the batteries if not used for long periods of time to prevent damage to the hand held remote.
FUNCTIONS OF TRANSMITTER
1. FAN SPEED：
1 : Turn on ceiling fan at 1st speed (lowest speed)
2 : Turn on ceiling fan at 2nd speed
3 : Turn on ceiling fan at 3rd speed
4 : Turn on ceiling fan at 4th speed
5 : Turn on ceiling fan at 5th speed
6 :Turn on ceiling fan at 6th speed (high speed)
: Turn off ceiling fan.
Press for forward/reverse airflow of ceiling fan.
:Natural breeze: Fan speed will modulate to simulate
a natural breeze.
. FAN TIMER:
1hr：Setting up that the ceiling fan will turn off after 1 hours automatically.
3hr：Setting up that the ceiling fan will turn off after 3 hours automatically.
6hr：Setting up that the ceiling fan will turn off after 6 hours automatically.
2. LIGHT:
ON/OFF—Press and release instantly to turn on or
off the light.
Press and hold to brighten light to the desired level and release.
Press and hold to dim light to the desired level and release.