Installation Instructions

CEILING FAN REMOTE CONTROLLER

OPERATION AND INSTALLATION INSTRUCTIONS

(Please keep this instruction pamphlet.)

IMPORTANT POINTS TO REMEMBER:

1. Read and save these instructions.

2. Please note that all fixed wiring appliances should be installed by a qualified electrician.

3. The supply to the remote control receiver should be connected through a mains switch, i.e. existing wall switch.

4. Disconnect from power supply at wall switch before working on remote control receiver or ceiling fan.

5. Install receiver into the ceiling fan canopy of the fan to ensure proper protection.

6. This unit is to be used for the control of ceiling fan and in an AC120V 60Hz power supply only.

7. Do not install in wet locations or immerse in water.

8. Do not pull on or cut leads shorter.

9. Do not drop or bump the unit.

10. PLEASE NOTE: The battery will weaken with age and should be replaced before leaking takes place as this will

damage the transmitter. Dispose of used battery properly, keep the battery out of reach of children.

11. CAUTION: To reduce the risk of fire or injury, do not use this product in conjunction with any variable (rheostat)

wall control.

INSTALLATION INSTRUCTIONS

1. Once the connection has been made, the receiver inserts into the drop rod hanging bracket. The canopy comes

up to cover the receiver and bracket.

Fig 1

CHANNEL SETTING STEPS:

1. Make sure power to the fan is off. Open the remote battery cover and install 1pcs DC12V battery. (Fig.

2).

2. Change the dip switch from 0 to 1 (Fig. 2).

Turn on power to the fan, and within 30 seconds press and hold the “SET” button to allow the handset

and receiver to pair. Light (if installed) will flash twice and turn off and fan will turn off. This confirms

that the setting is active and ok.

DIP SWITCH – 0 & 1

IMPORTANT

YOU MUST SET CEILING FAN MANUAL SWITCH TO HIGH SPEED AND LIGHT KIT (IF ANY) TO ON

POSITION BEFORE OPERATING REMOTE CONTROL.

CAUTION: INCORRECT WIRE CONNECTION WOULD DAMAGE THIS RECEIVER.

PAGE 1
CEILING FAN REMOTE CONTROLLER OPERATION AND INSTALLATION INSTRUCTIONS (Please keep this instruction pamphlet.) IMPORTANT YOU MUST SET CEILING FAN MANUAL SWITCH TO HIGH SPEED AND LIGHT KIT (IF ANY) TO ON POSITION BEFORE OPERATING REMOTE CONTROL. IMPORTANT POINTS TO REMEMBER: 1. Read and save these instructions. 2. Please note that all fixed wiring appliances should be installed by a qualified electrician. 3. The supply to the remote control receiver should be connected through a mains switch, i.e.
PAGE 2
0: All handsets and receivers are factory pre-set to the same channel. You can operate the fan without doing a channel setting above but we recommend that you set an individual channel for your fan. 1: This is to allow for each handset and receiver to be set on an individual channel. FIG. 3 FIG.
PAGE 3
ore of the following measures: - Reorient or relocate the receiving antenna. - Increase the separation between the equipment and receiver. - Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. - Consult the dealer or an experienced radio/TV technician for help. NOTE 2: Any changes or modifications to this unit not expressly approved by the party responsible for com pliance could void the user's authority to operate the equipment.