User's Manual

RF EXPOSURE WARNINGS TO USERS
SATEL-TA11 radio modem module
FCC ID: MRB-SATEL-TA11
INFO LETTER
May 19
th
, 2009 / MaritaL
Page 1 of 1
Warnings to be added to the user guide of SATEL-TA11 radio modem module°
WARNING! Users of SATELLINE-M3-R1, -M3-T1, SLR1and SLR2 radio modem modules in
North America should be aware, that due to the allocation of the frequency band 406.0 –
406.1 MHz for government use only, the use of radio modem on this frequency band
without a proper permit is strictly forbidden.
Warning – RF Exposure
"Warning: To comply with FCC RF exposure compliance requirements, a separation distance of at
least xx cm must be maintained between the antenna of this device and all persons. This device must not
be co-located or operating in conjunction with any other antenna or transmitter."
Modification warning statement
"Changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment."
Class B digital device statement
"Note: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in
a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help."