User's Manual

FLEX-HDD(FHD-352, FHD-252) User’s Manual

I. General Information

H/W & S/W REQUIREMENTS

For Mac OS Users :

1. A Macintosh computer with built-in FireWire™ and USB ports.

2. Mac OS 8.6 or higher

For Windows PC Users :

1. A PC with at least 200MHz Pentium and built-in USB, FireWire™ port(s) or a USB, FireWire™ PCI Card

2. Windows 98SE or higher

PACKAGE CONTENTS

(1) 1394 connecting cable(6pin-6pin)

(1) USB connecting cable(A to B)

(1) AC power cable( FHD-352UF User’s only)

*** Note for FHD-252Users

Some notebook computers may not supply the required voltage to power your external-HDD. In this case,

the external AC/DC power adapter(optional) will be needed.

(1) Install driver CD

(1) User’s Manual

(1) Carrying bag(option)

II. Installation & Operation

CASE ASSEMBLING

1. Press down the top of the case and pull it apart.

Note: Try not to use sharp objects to open it; it might damage the inner IC broad.

2. Remove the case and disassemble the unit.

3. Connect the IDE hard disk to the connector.

Note: Make sure the pins match the connecter

4. Connect the DC power cable to the hard disk(FHD-352 Users only)

5. Secure the hard drive on the bottom of case with 4 screws(big size) provided after connecting.

Note: Do not tighten the screws too much.

6. Get ready to put everything back together and secure top and bottom cases with 2 screws(small size).

Note: Do not connect power at this time

PAGE 1
FLEX-HDD(FHD-352, FHD-252) User’s Manual I. General Information H/W & S/W REQUIREMENTS For Mac OS Users : 1. A Macintosh computer with built-in FireWire™ and USB ports. 2. Mac OS 8.6 or higher For Windows PC Users : 1. A PC with at least 200MHz Pentium and built-in USB, FireWire™ port(s) or a USB, FireWire™ PCI Card 2.
PAGE 2
FIREWIRE INSTALLATION For Mac OS users 1. Insert provided cd-rom into your cd-drive. The cd icon will pop up on the screen. 2. On the cd-rom window, you’ll find FWSBP2DiskDriver in FireWire folder. 3. Make sure you have FireWire Enabler and FireWire Support in your extension folder. You may already have FireWire Enabler and FireWire Support in your Extension folder if you are using Mac OS 8.6 or higher. 4. Copy FWSBP2DiskDriver to Extension Folder in System folder. 5.
PAGE 3
For Windows98 Users 1. Insert provided cd-rom into your cd-drive. 2. On the cd-rom window, you’ll find Setup file in USB\Windows98 folder 3. Double click this file and INSTALL then the drive will be installed automatically. 4. Plug the AC power cable into the power port on the USB Hard Drive.(FHD-352 Users only) 5. Plug one each of the USB cable into USB port on your PC and on your Hard drive. 6. You’ll need to format the USB Hard Drive to work on your PC.