OEM MANUAL November 2013 2.433-2.449 GHz Frequency Hopping Transceiver Module Model: D-CCA-MOD-24G-1 FCC ID: R73MOD-24G-1 REV 2 The Sapling Company, Inc. 1633 Republic Road Huntingdon Valley, PA 19006 USA 215.322.6063 P. 215.322.8498 F. www.sapling-inc.
Page 2 of 7 OEM INTEGRATOR ATTESTATION a. This module is for OEM installation only. b. The OEM is responsible for ensuring that the end-user has no manual instructions to remove or install module. c. The module is limited to installation in mobile or fixed applications, according to Part 2.1091(b). d. Separate approval is required for all other operating configurations, including portable configurations with respect to Part 2.1093 and different antenna configurations. e.
Page 3 of 7 Introduction This module is only authorized to be installed in fixed mount installation and may not be installed in a mobile or portable device. The MOD-24G-1 RF module is to be used in Sapling Digital Clocks such as the SBD 3000 Series Clocks and equivalent models. The module is only be connected to and installed in other Sapling products. Specifications The PCB antenna gain is +3.3Db maximum. The maximum output power will be 18 dBm.
Page 4 of 7 Installed The picture below shows the MOD-24G-1 RF module installed in a digital clock. It shows the SBL-G3S-256-1R, the connectors to the rest of the Sapling Wireless Clock System, and the FCC ID, and the Compliance Label. SBL-G3S-256-1R J2 RF MODULE INTERFACE MOD-24G-1 Antenna(s) The antenna(s) used for this transmitter must be installed to provide a separation distance of at least 5.
Page 5 of 7 SBL-G3S-256-1R MOD-24G-1 FCC ID: R73MOD-24G-1 J2 RF MODULE INTERFACE POWER & DATA J2 RF MODULE INTERFACE PIN 1* RF V+ PIN 2 RF SEL PIN 3 RF CS PIN 4 PAEN PIN 5 GPO 0 PIN 6 EN PIN 7 RF GPO 2 PIN 8 HGM PIN 9 RF SO PIN 10 RF GND PIN 11 RF CLK PIN 12 RF GND PIN 13 RF SI PIN 14 RF GND * PIN 1 IS THE SQUARE PAD. The Sapling Company, Inc. 1633 Republic Road Huntingdon Valley, PA 19006 USA 215.322.6063 P. 215.322.8498 F. www.sapling-inc.
Page 6 of 7 SBL-G3S-256-1R Label The label below is an example of the FCC ID and the Compliance Label. Operation The MOD-24G-1 RF module will transmit the time for 240 ms and receive the time for up to 20 seconds once a minute. The Sapling Company, Inc. 1633 Republic Road Huntingdon Valley, PA 19006 USA 215.322.6063 P. 215.322.8498 F. www.sapling-inc.
Page 7 of 7 FCC Statement: This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS EQUIPMENT. SUCH MODIFICATIONS COULD VOID THE USER’S AUTHORITY TO OPERATE THE EQUIPMENT.