Instruction Manual Wireless Intercom F60 Features of F60 ● Full Duplex Function (One-to-One ) Communication between rooms in your home or office. ● GROUP Function (One-to-Many) Communication for calling family, office and school, delivering announcemen or emergency calls. ● Large LCD display (more intuitive and easier to operate) ● There are two sets of duplex A/B optional (A to A, B to B, A cannot communicate with B).
Intercom Controls Mirco USB 5V USB cable Adaptor
• Hang up Button: During a duplex call, press this button to hang up and exit the duplex communication state. Return to the standby state. • GROUP Button:A broadcasting function (one-to-many) to communicate with all other intercoms, (default group = 1)just hold GROUP button and talk .
GROUP channel. Press VOL+ /VOL- to select the option you want to set, press the dial key to save and exit. • VOL+ Button: Short press to increase the volume; in the menu setting state, short press to select options upward. • VOL- Button: Short press to decrease the volume; in the menu setting state, short press to select options downward. Set up instruction 1. Place the intercom near an AC power wall plug or power strip. Connect the power cable. 2. The LCD screen will be lighted.
OPERATION ● Full Duplex function(One-to-One) 1. Select and press the number of the intercom you wish to talk to, and the LCD will display the number you want to call and flash indicating you are ready to talk to that intercom. 2. Press the "Dial" button to begin a conversation with that intercom. While transmitting, your LCD display will turn red (the LCD TX logo will also light up, and the call tone will also sound), indicating that you are transmitting.
●Menu Settings Long press the MENU button for 3 seconds to enter the menu function setting, short press the MENU button to switch A/B from CHANNEL, press again to switch to the GROUP channel setting. After the setting is completed, press the "Dial" "Hang up" "GROUP" key to save and exit. ●Change the Channel Number After entering the menu setting state, CHANNEL will light up and the corresponding channel number will flash.
●TROUBLE SHOOTING ● Faults during start-up 1) Ensure the power cable is connected and working properly 2) Verify AC/USB charge adapter and make sure using 5V/1A adapter ● Noise, no sound or other sound interference. 1) The distance between two devices should be over 2 meters and adjust the volume to decrease interference 2) Verify all intercoms are at least 1 meter (3ft) away from any high current electrical equipments such as motors, blowers, heaters or other radios, etc.
● Never try to open the INTERCOM or repair it by yourself to avoid unpredictable issues ● Clean the unit by wiping it with a soft dry towel. You can also use a soft cloth moistened with mild neutral detergent and water. Never use thinner, benzene, or other volatile agents or alcohol to clean the unit directly. ● Do not allow the unit to be exposed in sunlight for a long time, place it far away from any heat resources (greater than 140 degree F).
This device has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This device generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.