User Guide

51
Terminal
The COMPUTER IN 2/MONITOR OUT terminal on the back
of the projector is switchable for computer input or monitor
output. (See page 9) Select Computer 2 or Monitor Out
with the Point
Ÿźbuttons.
Computer 2 . . computer input
Monitor Out . . monitor out
Terminal function is not available when Computer 2 is
selected to the input source. Change the input source to the
others (Computer 1, Video or S-video) so that the Terminal
function will be available. (pp.25, 27, 38, 39)
Power management
Time left before Lamp is off.
Power management
For reducing power consumption as well as maintaining
the lamp life, the Power management function turns off the
projection lamp when the projector is not operated for a
certain period.
Select one of the following options:
Ready.................. When the lamp has been fully cooled
down, the POWER indicator changes
to green blinking. In this condition, the
projection lamp will be turned on if the
input signal is reconnected or any button
on the top control or remote control is
pressed.
Shut down .......... When the lamp has been fully cooled
down, the power will be turned off.
Off ....................... Power management function is off.
Timer................... If the input signal is interrupted and
no button is pressed for more than
30 seconds, the timer display with No
signal appears. It starts the countdown
until the lamp is turned off. Use the Point
Ÿź buttons to set the Timer(1~30min.).
3 Note:
Factory default is Ready: 5 Min.
Direct on
When this function is set to On, the projector will be
automatically turned on just by connecting the AC power
cord to a wall outlet.
3 Note:
Be sure to turn off the projector properly (see “Turning
Off the Projector” on page 20). If the projector is turned
off in the incorrect sequence, the Direct on function does
not work properly.
Setting