Installation Manual

Installation Manual

This module is to be installed only by the professionals and used only with a

WLAN Module for

projector produced by

SANYO Electric Co., Ltd.. When this WLAN Module is installed in the

projector, we shall consider the following points;

1. Since

“QXXAVC922---P” owns its FCC ID/IC Number, we shall affix an exterior label on

the outside of the product if the FCC ID is not visible. The exterior label shall use wording

such as either ”Contains Transmitter Module FCC ID: NPKAVC922 / IC: 339D-AVC922”

or “Contains FCC ID: NPKAVC922 / IC: 339D-AVC922”.

2. “QXXAVC922---P” complies with requirements of sub-sections 15.19(a)(3) in FCC Rules

Part 15 Subpart C. The manual statement 15.19 (a)(3) is included User Guide of the product.

3. “

QXXAVC922---P” is to be installed only by the professional line operator as shown in

following pictures. (Fig 1 and 2)

Fig 1. Front side of “

QXXAVC922---P”

WLAN Module

Fig 2. Front view of “QXXAVC922---P” to be equipped for a projector (example)

Module Board on

etwork Assembl

Boar

Location of Network

Assembly Board in a

projector

PAGE 1
Installation Manual This module is to be installed only by the professionals and used only with a WLAN Module for projector produced by SANYO Electric Co., Ltd.. When this WLAN Module is installed in the projector, we shall consider the following points; 1. Since “QXXAVC922---P” owns its FCC ID/IC Number, we shall affix an exterior label on the outside of the product if the FCC ID is not visible.
PAGE 2
There isn’t an official user manual for this WLAN Module (QXXAVC922---P). However, user manuals of final product, which have the module, must contain notification corresponding to the following description. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. (This device complies with Part 15 of FCC Rules and RSS-Gen of IC Rules.