M12S 2.
M12S 2.4GHZ FH4T RADIO CONTROL SYSTEM USER'S GUIDE TABLE OF CONTENTS GENERAL Introduction..........................................................................................................................................................................................................................................Page 2 Packaging...........................................................................................................................................................................
M12S 2.4GHZ FH4T RADIO CONTROL SYSTEM USER'S GUIDE GENERAL SERVICE AND SUPPORT If you have any questions or concerns, we're here to help. If you encounter a problem with your radio control system, first check the Troubleshooting Guide section on pages 97 ~98. If you require further help, please contact us directly. In North America Only: Global Services 18480 Bandilier Circle Fountain Valley, CA 92708 Telephone: 1-714-963-0329 Fax: 1-714-964-6236 Email: service@airtronics.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
M12S 2.4GHZ FH4T RADIO CONTROL SYSTEM USER'S GUIDE GENERAL 2.4GHZ FREQUENCY BAND PRECAUTIONS • The 2.4GHz frequency band may be used by other devices, or other devices in the immediate area may cause interference on the same frequency band. Always before use, conduct a bench test to ensure that the servos operate properly. Also, conduct checks with the transmitter as distant as possible from your Model. • The response speed of the receiver can be affected if used where multiple 2.
T M12S 2.4GHZ FH4T RADIO CONTROL SYSTEM USER'S GUIDE SYSTEM FEATURES GENERAL • 4-Channel 2.4GHz FH4T Digital High-Response Telemetry System with Advanced Programming • Large LCD Screen Features STATUS screen, ASSIGN screen and TELEMETRY screen* • High-Power FH4T Technology Provides the Best Reception and Connectivity, Giving Racers Added Assurance • 4-Cell Dry Battery Holder for Lighter Weight - Also Accepts Optional Ni-Cd/Ni-MH Batteries or 2S Li-Po/Li-Fe Battery Pack • Includes RX-472 2.
M12S 2.4GHZ FH4T RADIO CONTROL SYSTEM USER'S GUIDE TRANSMITTER OVERVIEW DIAGRAMS GENERAL Use the diagrams in this section to familiarize yourself with the layout of your transmitter. Descriptions of these features can be found in the Transmitter and Receiver Overview Diagram Descriptions section on pages 8 ~ 9. The transmitter antenna is mounted internally and is located in the vertical back portion of the carrying handle.
M12S 2.
M12S 2.4GHZ FH4T RADIO CONTROL SYSTEM USER'S GUIDE RECEIVER OVERVIEW DIAGRAM, CONNECTIONS AND MOUNTING GENERAL Use the diagrams in this section to make receiver connections and to familiarize yourself with the RX-471 4-Channel 2.4GHz FH4 Super Response receiver included with your M12S radio control system. Descriptions of the features can be found in the Transmitter and Receiver Features Descriptions section below and on the next page.
M12S 2.4GHZ FH4T RADIO CONTROL SYSTEM USER'S GUIDE TRANSMITTER AND RECEIVER OVERVIEW DIAGRAM DESCRIPTIONS GENERAL Back Key: Pressing the BACK key returns the Programming Cursor to the previous menu. Press the BACK key repeatedly to return to the STATUS screen. Battery Compartment: Houses the four 'AA' Alkaline cells that power the transmitter. Alternatively, the transmitter can be powered using four 'AA' Ni-Cd or Ni-MH rechargeable batteries or a 2S Li-Po or Li-Fe battery pack.
M12S 2.4GHZ FH4T RADIO CONTROL SYSTEM USER'S GUIDE TRANSMITTER WARNING ALARMS AND LED CONDITION INDICATORS GENERAL The M12S is equipped with several different Audible Warning Alarms to warn you of an abnormal transmitter condition. In addition, LED1, LED2 and the R-MODE LED are used to indicate various transmitter conditions at a glance. Audible Warning Alarms The audible alarms listed below may also be accompanied by an on-screen warning.
M12S 2.4GHZ FH4T RADIO CONTROL SYSTEM USER'S GUIDE TRANSMITTER BATTERY OPTIONS GENERAL The M12S transmitter's Operating Voltage Range is 4.0 ~ 9.6 volts. This allows you to use several different battery options (not included), depending on your preference. Alkaline - In the default configuration, the transmitter is designed to be powered using four 'AA' Alkaline batteries. This results in a transmitter that is lightweight and well-balanced for unmatched comfort.
M12S 2.4GHZ FH4T RADIO CONTROL SYSTEM USER'S GUIDE STEERING WHEEL AND THROTTLE TRIGGER SPRING TENSION ADJUSTMENT GENERAL The spring tension of the Steering Wheel and Throttle Trigger can be adjusted to best suit the user. Some users may prefer the Throttle Trigger and/or Steering Wheel to feel 'firmer' and some users may prefer them to feel 'softer'. It all depends on your personal preference.
M12S 2.4GHZ FH4T RADIO CONTROL SYSTEM USER'S GUIDE OPTIONAL STEERING WHEEL INSTALLATION GENERAL An optional larger diameter Steering Wheel is included to best suit the user. Some user's feel that the larger diameter Steering Wheel makes the Steering operation seem finer. To install the optional larger diameter Steering Wheel, follow the steps below: 1) Use a 7mm nut driver to remove the Steering Wheel retaining nut, then pull the Steering Wheel straight off.
M12S 2.4GHZ FH4T RADIO CONTROL SYSTEM USER'S GUIDE THROTTLE TRIGGER POSITION ADJUSTMENT GENERAL The position of the Throttle Trigger can be adjusted forward or backward to change the feel of the Throttle Trigger during use. Some users may prefer the Throttle Trigger positioned farther forward and some users my prefer the Throttle Trigger positioned farther back. It all depends on your personal preference.
M12S 2.4GHZ FH4T RADIO CONTROL SYSTEM USER'S GUIDE OPTIONAL STEERING WHEEL ANGLE PLATE INSTALLATION GENERAL Two optional Steering Wheel angle plates (one Right and one Left) are included that angles the position of the Steering Wheel and Trim Switch assembly. Some users may find that angling the Steering Wheel to the Right or Left may be more comfortable during use. 'R' and 'L' are molded into the angle plates to differentiate them.
M12S 2.4GHZ FH4T RADIO CONTROL SYSTEM USER'S GUIDE DRIVING POSITION ADJUSTMENT GENERAL The position of the Steering Wheel can be switched from the Right side to the Left side to accommodate Left-handed drivers. This makes the M12S much more comfortable for natural Left-handed drivers to use. A A To change the driving position for Left-handed use, follow the steps below: 1) Using a 2.
M12S 2.4GHZ FH4T RADIO CONTROL SYSTEM USER'S GUIDE PROGRAMMING KEYS OVERVIEW AND FUNCTIONS GENERAL Moving around the various screens and programming the transmitter is accomplished using the ENTER key (Push-Button Rotary Dial), the SELECT switch and the BACK key. PRO TIP: While navigating Programming Menus and changing Programming Values, keep the following in mind: to choose a menu from the STATUS screen, use the SELECT switch. To open a menu, press the ENTER key.
M12S 2.4GHZ FH4T RADIO CONTROL SYSTEM USER'S GUIDE DISPLAY SCREENS OVERVIEW GENERAL Use the information in this section to familiarize yourself with the layout and different indicators and displays that comprise the STATUS screen. The STATUS screen displays all pertinent information, such as the Model Name, Modulation Type, Timer, Voltage and much more. The STATUS screen will always be displayed after the BOOT screen unless you change that option in the SYSTEM BOOT menu.
M12S 2.4GHZ FH4T RADIO CONTROL SYSTEM USER'S GUIDE DISPLAY SCREENS OVERVIEW GENERAL STATUS Screen Overview Diagram Descriptions, Continued.... On-Time Indicator: Displays the current cumulative On-Time of the transmitter in Hours and Minutes. Racing Mode Indicator: Indicates whether Racing Mode is Active or Inhibited and Which Racing Mode (R1 ~ R5) is Active. RF Indicator: Indicates whether the transmitter is sending an RF signal or not. Trim Display: Displays the current position of channel Trim.
M12S 2.4GHZ FH4T RADIO CONTROL SYSTEM USER'S GUIDE MAIN MENUS OVERVIEW GENERAL The four main menus described in the previous section all share the same basic layout as illustrated below. Use this information to familiarize yourself with the layout and the information presented.
M12S 2.4GHZ FH4T RADIO CONTROL SYSTEM USER'S GUIDE TELEMETRY SCREEN OVERVIEW GENERAL The TELEMETRY screen displays Telemetry Data, such as RPM or Speed, Temperature, Receiver Voltage and more. For information about making Telemetry option changes that effect how and what Telemetry Data is displayed on the various TELEMETRY pages, see the LOG SETUP Menu section on pages 48 ~ 56. Telemetry integration requires the use of an Airtronics 2.
M12S 2.4GHZ FH4T RADIO CONTROL SYSTEM USER'S GUIDE TELEMETRY SCREEN OVERVIEW GENERAL TELEMETRY Screen Overview Diagram Descriptions, Continued.... Numerical Telemetry Data: Displays the Telemetry Data in a numerical format. Page Indicator: Indicates the current Page within the Telemetry Data Stream that Telemetry Data is currently being displayed on. Receiver Voltage Display: Displays the current Voltage of the receiver battery.
M12S 2.4GHZ FH4T RADIO CONTROL SYSTEM USER'S GUIDE TRANSMITTER AND RECEIVER BINDING GENERAL The Binding function allows you to Bind the transmitter and receiver pair. When new, it is necessary to pair the transmitter and receiver to prevent interference from transmitters operated by other users. This operation is referred to as 'Binding'.