User's Guide

ManualsBrandsSANSI ManualsElectronicsLED Grow Light

Table Of Contents

Smart LED grow light

User Guide

Product Overview

Thanks for purchasing our product, to ensure full understanding of the product and know how to

use it properly, please read the user guide thoroughly and keep it for potential use.

Installation

WARNING！Risk of burn! Do not touch LED light source or the housing

during use.

WARNING！Risk of electric shock! Disconnect power before servicing.

Lamp holder

Electrical cavity

Ceramic module

LED light source

E26 lamp base

Put the lamp holder screwed to the E26 lamp base.

Summary of content (4 pages)

PAGE 1
Smart LED grow light User Guide Product Overview Thanks for purchasing our product, to ensure full understanding of the product and know how to use it properly, please read the user guide thoroughly and keep it for potential use. LED light source Ceramic module Electrical cavity Lamp holder Installation WARNING！Risk of burn! Do not touch LED light source or the housing during use. WARNING！Risk of electric shock! Disconnect power before servicing.
PAGE 2
App installation Search “Stellar BLE” in Google Store or App Store to get the App. Note：If it has been installed on the phone, make sure the app is the latest version. Add devices 1. Turn on the light after the installation. 2. Open the Stellar BLE App, make sure the Bluetooth on your phone is on, get the phone close to the device. 3. Tap “+” on the top right of the “Light” interface, tap “Add Devices” to start searching devices.
PAGE 3
7. Do not install / place the product in adverse ambient conditions or in rooms where heat sources, hot steam, corrosive gas, flammable gas, vapors or dust are present. 8. For indoor use only! Do not expose the product to rain or wet conditions. 9. The light source of this product is not replaceable. When the light source reaches the end of its life, the whole luminaire has to be replaced.
PAGE 4
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.