DT-210/DT-210L/DT-210V GB Revision 1
1
Controls Stereo/Mono/Speaker switch Memory button 3 Tuning Up/Down 4 Earphones Jack 5 Volume Control 6 Power switch 7 Display 8 Memory Recall 9 DBB (Deep Bass Boost) selection 10 Band selector 11 Belt Clip holder 12 Lock switch 13 Battery compartment 14 Belt Clip 1 2 GB Display A Waveband indicator DBB on C Key lock indicator D Low battery indicator E Frequency display F Memory preset G Stereo indicator H 90 minutes auto shut off indicator B 2
Installing batteries 1. Position the radio face down. 2. Press the catch and slide in the direction of the mark. 3. Lift up the battery cover and insert 1xUM-4 (AAA) size on each side of battery compartment. Make sure the batteries are positioned in accordance with the diagram indicated. 4. Replace the battery cover. Battery replacement The battery indicator will appear and flash in the display when the batteries are in need of replacement .
Addendum Important: Please always replace the batteries within 3 minutes and always with fresh batteries. If the radio malfunctions after battery replacement, 1. Switch off the radio and remove the batteries. 2. With the aid of a suitable implement (the end of a paper clip or pen), press the RESET button located in the battery compartment for about 5 seconds, this will reset the microprocessor and clear all stations stored in the preset memory.
Search tuning 1. Switch on the radio by pressing the Power button. Note: The radio is originally set to be 90 minutes auto shut off after Power is switched on GB ( symbol will appear on the display). If you don’t need this feature, press Power button for more than 2 seconds until symbol removed from the display. 2. Select the required waveband by repeatedly pressing the Band button. On FM and TV band (DT-210V only ), connect the supplied earphones as the antenna or the wire antenna.
Manual tuning 1. Switch on the radio by pressing the Power button. 2. Select the required waveband and connect the supplied earphones or wire antenna for FM and TV band (DT-210V) listening. On AM(MW) or LW band (DT-210L), rotate the radio for best reception. 3. A single press on either the Tuning Up/ Down will change the frequency up or down. Adjust the volume control to the required level.
Recalling a preset station 1. Switch on the radio. 2. Press RECALL button and Tuning Up/ Down to recall required preset station Display will flash preset station. GB 3. Press RECALL button again, once the required preset station is found. Lock Switch The lock switch located on the rear cabinet is used to prevent unintentional operation. 1. Slide the lock switch to the up locked position , the symbol will appear in the display. The power and all other buttons will be disabled.
Earphones and antenna The earphones also acts as the FM antenna when plugged into the earphones jack. While listening via speaker, you may plug the supplied wire antenna into the earphones jack, and set the ST/MO/SP switch to the SP (speaker) position. ST/MO/SP(Stereo/Mono/Speaker) 1. Switch the switch to SP (speaker) position, while you listen to the radio program via speaker. Make sure to plug the supplied wire antenna or the earphones to get best FM reception. 2.
Change AM (MW) band tuning step ( available only on DT-210/V not for LW version ) In Europe and other parts of the world, AM GB (MW) tuning step are 9 kHz, in America the AM tuning step is 10 kHz. To change the AM tuning step from 10 kHz to 9 kHz, proceed as follows, 1. Press Tuning Down button then the power button to switch on the radio, the radio will be changed into 9 kHz tuning step on AM band. To change the AM tuning step from 9 kHz to 10 kHz, proceed as follows, 1.
DBB (Deep Bass Boost) button Press DBB button to activate the Deep Bass Boost to have stronger bass sound, display will appear DBB symbol. Another press will cancel the DBB. Note: Suggest to activate the DBB only using earphones.
Specification Power Supply: 2 x AAA (UM-4) (R03) batteries Output Power: 100 mW (10% T.H.D. 1 kHz) GB Earphones socket: 3.5 mm dia stereo 32 ohm Frequency range: FM 87.50 - 108 MHz AM(MW) 522 - 1629 kHz (DT-210/L) 520 - 1710 kHz (DT-210V) LW 153 - 279 kHz (DT-210L) TV 2 - 13 CH (DT-210V) Battery Life: Approx. 24 hours ( via speaker ) using Alkaline battery Approx. 32 hours ( via earphones ) using Alkaline battery The company reserves the right to amend the specification without notice.