Job Site Radio Instruction manual F Radio de chantier Manuel d’instructions LS Radio de Trabajo Manual de instrucciones GB XRM04 IMPORTANT: Read Before Using. IMPORTANT : Lisez les instructions avant l’utilisation. IMPORTANTE: Leer antes de usar.
3 4 5 B C D A I H E G F 6 (19) 14 12 13 2 3 4 5 11 6 7 8 1 10 (20) 15 (21) (22) 17 18 18 16 18 18 (23) 1 2 (24) 9
14 16 2 3 26 25 26 25 4 5 25 25 6 7 3
13 27 28 8 9 10 9 1 10 4
ENGLISH (Original instructions) IMPORTANT SAFETY INSTRUCTIONS WARNING: When using electric tools, basic safety precautions should always be followed to reduce the risk of fire, electric shock, and personal injury, including the following: 1. Read this instruction manual and the charger instruction manual carefully before use. 2. Clean only with dry cloth. 3. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. 4.
For United States: Cautions to the user The changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. RF exposure statements IMPORTANT NOTE: To comply with the FCC RF exposure compliance requirements, the antenna(s) used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter.
The following table indicates the operating time on a single charge in Radio mode. 7.2 V 1.0 Ah AT SPEAKER OUTPUT = 50 mW + 50 mW unit Hour (APPROX.) Battery Cartridge Voltage Battery capacity 10.8 V 14.4 V 18 V BL7010 Radio/AUX BT + USB 5.5 0.8 BL1411G 1.5 L1451 1.1 Ah BL1811G 5.5 1.8 L1851 BL1014 1.5 BL1415 1.8 BL1413G 1.3 Ah 7.5 L1453 BL1815 BL1813G 2.0 L1853 BL0715 1.5 Ah 7.5 BL1415N BL1815N BL1820 2.0 Ah BL1820B 8.5 11 1.0 2.0 2.5 3.2 BL1430 4.0 BL1430B 3.
Installing or removing Cluster battery cartridge (Fig. 6 & 7) Using the soft bended rod antenna (Fig. 9) • To insert the battery cartridge, align the tongue on the Straight up the soft bended rod antenna as shown in the battery cartridge with the grove in the housing and slip figure. it into place. • To remove the battery cartridge, take the battery out of the terminal while pressing the buttons on the side of cartridge. Return the battery compartment locker to the original position.
• FM/AM will flash approx. 10 seconds. Within this period, only manual tuning is allowed. • If volume adjustment is desired while FM/AM is flashing, press the Tuning control knob to stop the flash and you can rotate the Tuning control knob to adjust sound level. 1. Press the Power button as needed to select the FM band and tune to the desired FM station as previously stated. 2. Press and hold Menu/Info button 3. Rotate the Tuning control knob 4. Rotate the Tuning control knob to tune to a station. 5.
confirm the setting. Then rotate the Tuning control ONCE – the alarm will sound once knob DAILY – the alarm will sound everyday to select the desired minute, and press the Tuning control knob WEEKDAY – the alarm will sound only on weekdays to confirm the setting. 4. Rotate the Tuning control knob until “DATE ADJ” appears on the display. Press the Tuning control knob 5. Rotate the Tuning control knob to confirm the setting.
Disabling/cancelling alarms 4. To turn off the loudness function, select OFF and To disable an active alarm, either press the Power button , or press and hold the corresponding alarm button press the Tuning control knob to confirm the setting. to cancel the alarm. Auxiliary input socket Snooze Two 3.5 mm stereo Auxiliary Input sockets are provided. 1. When the alarm sounds, press any button other than the Power button will silence the alarm for 5 minutes. “SNOOZE” will appear on the display. 2.
Note: a) The radio can pair with 8 Bluetooth® devices at most. When you pair Bluetooth® devices more than this number, pairing history will be overwritten from the oldest pairing history. b) If there are 2 Bluetooth® devices searching for your radio, it will show its availability on both devices. c) If your Bluetooth® device is temporarily disconnected to your radio, then you need to manually reconnect your device again to the radio.