User's Manual

Install and Operation
1. Power on bridge ZW-01, then use you Firefox to connect correct IP of ZW-01.
you can install “CyberFinder”，then use it to connect to bridge, for detail, please
check the manual of bridge.
2. Click right key of mouse select MODE, Add Device then select OK to add device
into Z-wave net, but the process will finish until device acknowledges the request.
3. Put ZW-02A with electromagnetic block and push micro switch to connect it into
Z-wave net.
4. Then you can get trig signal when electromagnetic block out of ZW-02A from
internet with FireFox or IE in your computer,
FCC Note:
This device complies with part 15 of FCC rules operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2)this device
must accept any interference that may be received, including interference that may
cause undesired operation.
THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV
INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS TO
THIS EQUIPMENT. SUCH MODIFICATIONS COULD VOID THE
USER’S AUTHORITY TO OPERATE THE EQUIPMENT.