Instructions / Assembly

SJCR México
Av. Universidad #1377-701
Colonia Axotla CP 01030
Del. Álvaro Obregón
MÉXICO, DF
T: [phone]
F: [phone]
[e-mail]
San Jamar
Chef Revival
555 Koopman Lane
Elkhorn, Wisconsin 53121
USA
T: +1.262.723.6133
F: +1.262.723.4204
[e-mail]
SJCR Europe
Schoorstraat 26A, bus-1
2220 Heist op-den Berg
BELGIUM
T: [phone]
F: [phone]
[e-mail]
SJCR Canada
3300 Bloor Street West
Center Tower, 11th Floor, Suite 3140
Toronto, ON M8X 2X3
CANADA
T: +1.416.760.7367
F: +1.416.207.2071
[e-mail]
MOUNTING INSTRUCTIONS
(Dispenser must be mounted level)
The user is responsible for the proper installation and use
of this dispenser.
Note: Hardware may not be included with your product.
If hardware is factory supplied, refer to mount ing
instructions located in hardware pack.
Equipment needed:
Measuring tape, level, screwdriver, eye protection, pencil,
drill and drill bit suitable for appropriate wall mounting
hardware. Assemble appropriate fasteners (screws, bolts,
anchors, washers, etc.) for mounting.
1. Determine position on wall/surface with unit open.
Through the holes at the back of the unit, use pencil to
mark the spots where the drilling will be necessary. Be
sure unit is level before marking holes. WARNING:
Proper function of this dispenser requires
level mounting. Try to mark spots as close as possible
to the outer edges. Mount upper center hole first.
2. Drill the marked spots on the wall/surface with
appropriate sized drill bit suitable for the wall material and
fasteners used.
3. Complete the installation. Be sure to use fasteners (and
anchors) in all mounting holes that are appropriate for the
wall/surface to which the dispenser will be mounted. The
installation should be done with a flat washer between the
head of the fastener and the inside back of the dispenser.
HANDLE INSTALLATION
INSTRUCTIONS
1. Remove key from the back
of dispenser.
2. Remove sticker from cover
and open dispenser.
3. Remove handle from inside
of dispenser.
4. While the cover is open, snap handle onto small piece
on right side of dispenser. Push in until you hear the
handle snap into place.
101838
Step 1 Open cover.
Insert roll
towel.
Step 2 Pull down and drape
so that paper is
hanging off the back
of the roll.
Step 3 Pinch paper by
rolling between
two rollers.
Step 4 Activate lever to feed
paper through rollers.
Close cover.
PAPER LOADING
SAN JAMAR TOWEL DISPENSER INSTRUCTIONS
((snap!))