Operating lnstructions For household use only Models VC-6000 SERIES VACUUM CLEANER ❈ Before operating this unit, please read the instructions carefully.
IMPORTANT SAFETY INSTRUCTIONS When using an electrical appliance, basic precautions should always be followed, including the following: READ ALL INSTRUCTIONS BEFORE USING THIS VACUUM CLEANER. WARNING To reduce the risk of fire, electric shock, or injury: 1. Do not leave appliance when plugged in. Unplug from outlet when not in use and before servicing. 2. Do not use outdoors or on wet surfaces. 3. Do not allow to be used as a toy. Close attention is necessary when used by or near children. 4.
IDENTIFICATIONS OF PARTS HANDLE AIR REGULATOR SUCTION HOSE DUST-FULL INDICATOR TUBE* CORD REWIND BUTTON BUTTON FOR SUCTION HOSE REMOVAL POWER CONTROL SWITCH* ON/OFF BUTTON CARRYING HANDLE FLOOR NOZZLE* CLAMPER FOR DUST BAG COMPARTMENT RUG/FLOOR SELECTOR Features marked with * may vary according to model. ASSEMBLING THE VACUUM - CLEANER READY FOR USE 2) Connect the suction tubes together (depending on model). 1) Connect the suction hose to the suction tube.
POWER CORD 1) PULLING OUT The power cord is long enough to be drawn out for convenience. 2) REWINDING When you have finished cleaning, disconnect the plug from the electrical outlet and simply press the cord rewind button lightly with your toe. NOTE : When removing the power cord from the electrical outlet, grasp the plug, not the cord. ON/OFF SWITCH With the cord plugged into an electrical outlet, start or stop the vacuum cleaner by pushing lightly downward on the switch with your toe.
DUST-FULL INDICATOR If the “Dust-Full” indicator changes to “RED” while you are cleaning, the dust bag requires replacement. NOTE : If the “Dust-Full” indicator continues to display “RED” even after changing the dust bag, turn the cleaner off and check whether the hose, tube or nozzle is clogged. USING THE ACCESSORIES CREVICE • Crevice tool for radiators, crevice, corners, between cushions. DUSTING • Dusting brush for furniture, shelves, books, etc.
USING THE BLOWER Located on the left rear side of the cleaner. 1) Disconnect the hose from the body of the cleaner. 2) Connect the hose clamper to the blow hole. PARK POSITION Located in the top rear side of the vacuum-cleaner, there is a nozzle support that can be used to park the nozzle during pauses in cleaning.
REPLACING THE DUST BAG 1) To open the dust cover of the dust bagcompartment, press the clamper upward. (The clamper is located at the front of the dust cover) 2) Remove the carrying bag from the cleaner. 3) After removing the used dust bag, insert the cardboard bag collar of the new dust bag into the carrying bag. 4) Press the dust cover down gently until the clamper relocks. NOTE : Used dust bag can be sealed by removing the film from the paper and sticking the latter over the suction opening.
MAINTENANCE OR REPLACEMENT OF THE FILTERS 1) INLET-FILTER. • Open the dust cover. • After detaching the filter, wash it lightly withwater, dry it in the shade, and then insert it in its original position. • Close the dust cover. 2) OUTLET-FILTER. • To open the filter cover, press front and pull it simultaneously. • Remove and replace the dirty microfilter. • Close the cover.
NOTE : For optimum efficiency, clean floor brush with crevice tool. TROUBLE SHOOTING PROBLEM CAUSE REMEDY Motor does not start. No power supply. Check cable, plug and socket. Suction force is gradually decreasing. Filter, nozzle, suction hose or tube is blocked. Remove the object. Cord does not rewind fully. Check that the cord is not twisted or wound unevenly. button.
DJ68-00097S REV(0.
