User Manual
ENG-12
☛ You do not need to preset the stations
manually if you have already set
them automatically.
➢ To enable the VCR to decode a
scrambled TV station, the decoder
must be switched on.
1 Press the MENU button on the remote control.
Result: The programming menu is displayed.
2 Press the corresponding
,
❷
or
➛
,
❿
buttons to
select the INSTALLATION option.
3 Press the OK button to select this option.
Result: The INSTALLATION menu is displayed.
4 Press the corresponding
or
❷
buttons, until
the MANUAL SET UP option is selected.
5 Press the
❿
button to select MANUAL SET UP
option.
Result: The TV STATION TABLE menu is
displayed.
6 Press the
or
❷
buttons to select a programme
number as required.
7 Press the
❿
button to preset the station.
Result: The MANUAL TUNING menu is displayed.
8 Press the
or
❷
buttons, until the SYSTEM is
selected.
9 Select the required system by pressing the
➛
or
❿
buttons.
10 Press the
or
❷
buttons until the CH selected.
11 Press the
➛
or
❿
buttons to start scanning.
Result: The frequency band is scanned and the
first station found is displayed.
If you know the number of the channel you want,
press the numeric buttons on the remote control
for example, for channel E21, first press “0” and
then press “2”, “1” (see page 30).
12 Press the
❷
button, until the DECODER is
selected.
13 Press the
❿
button to activate or deactivate use of
the decoder for the TV station, if necessary.
Presetting the Stations Manually
14 Press the
or
❷
buttons until the NAME is selected.
15 To change the programme’s name, press the
❿
button.
Result: The first letter of the name flashes.
16 To... Then...
Select a character Press the
or
❷
button until
in the name
the required character is displayed
(letters, numbers or “-” character).
Move to the next Press the
➛
or
❿
buttons
or previous respectively.
character
17 If you... Then...
Wish to store the ◆
Press the corresponding
station displayed or
❷
buttons, until the MFT
is selected.
◆ Press the
➛
or
❿
buttons to
adjust the picture, if necessary.
◆
Press OK to store the station .
Do not wish to ◆
Press the corresponding
store the station or
❷
buttons, until the CH
displayed is selected.
◆ Press the
➛
or
❿
buttons to
go on scanning the frequency
band and display the next
station
◆ Go back to the beginning of
Step 14
18 Repeat this procedure from Step 6 onwards, until
all the required stations have been stored.
19
On completion, press the MENU button three times
to exit the menu.
02119C SV-675F/XEB-ENG 3/15/04 10:46 AM Page 12