User Manual
ENG-11
➢
The number of stations automatically
stored by the VCR depends on the
number of stations that it has found.
8 If you wish to cancel the auto scanning before the
end, press the MENU button three times to exit the
menu.
➢ ◆ Once the auto scanning procedure
has finished, some stations may
have been stored more than once;
select the stations with the best
reception and delete the ones no
longer required (see page 12).
☛ You do not need to preset the stations if
you have already set them automatically
(see Plug & Auto Set Up on page 10).
Your VCR contains a built-in tuner used to
receive television broadcasts.
You must preset the stations received through
the tuner. This can be done:
◆ Plug & Auto Set up (see page 10)
◆ Automatically
◆ Manually (see page 12)
You can store up to 80 stations.
➢ To enable the VCR to decode a
scrambled TV station, the decoder
must be activated after the scan
(see pages 11).
1 Press the MENU button on the remote control.
Result: The programming menu is displayed.
2 Press the corresponding
,
❷
or
➛
,
❿
buttons to
select the INSTALLATION option.
3 Press the OK button to select this option.
Result: The INSTALLATION menu is displayed.
4 Press the corresponding
or
❷
buttons, until
the AUTO SET UP option is selected. And then
press the
❿
button to select this option.
5 Press the
or
❷
buttons to select your country.
☛The VCR searches for the stations
according to a preset preference list
corresponding to the country that you have
selected.
6 Press the OK button.
Result: A message appears, indicating that any
channels.
7 Press OK to start the auto scanning.
Result: ◆ The PLEASE WAIT indication flashes
on the television screen.
◆ The first frequency band is scanned
and the first station found is displayed
and stored.
◆
The VCR then searches for the second
station and so on.
◆ When the automatic scanning
procedure has finished, the VCR
switches automatically to programme1.
Presetting the Stations Automatically
02119C SV-675F/XEB-ENG 3/15/04 10:46 AM Page 11