User Manual

ManualsBrandsSamsung ManualsComputer: ServerSS38

Rack Installation Instructions

Review the documentation that comes with your rack cabinet for safety and cabling information. When

installing your server in a rack cabinet, consider the following:

Ÿ Two or more people are required to install the device in a rack cabinet.

Ÿ Take precaution to prevent overloading the power outlets when you install multiple devices in a

rack cabinet.

Ÿ Ensure the room air temperature is below 35°C (95°F).

Ÿ Do not block any air vents, usually 15 cm (6 in.) of air space provides proper airflow.

Ÿ Plan the device installation starting from the bottom of the rack cabinet.

Ÿ Install the heaviest device in the bottom of the rack cabinet.

Ÿ Do not extend more than one device out of the rack cabinet at the same time.

Ÿ Remove the rack doors and side panels to provide easier access during installation.

Ÿ Connect all power cords to properly wired and grounded electrical outlets.

You will need a flat-blade and a Phillips screwdriver during the installation. The following illustration shows the

items that you need to install the server in your rack cabinet. If any items are missing or damaged, contact

your place of purchase.

Use safe practices when lifting.

18 kg (39.7 lb)

32 kg (70.5 lb)

55 kg (121.2 lb)

Do not place any object weighing more than

50 kg (110 lb) on top of rack-mounted

devices.

>50 kg (110 lb)

Summary of content (6 pages)

PAGE 1
Rack Installation Instructions Review the documentation that comes with your rack cabinet for safety and cabling information. When installing your server in a rack cabinet, consider the following: Ÿ Two or more people are required to install the device in a rack cabinet. Ÿ Take precaution to prevent overloading the power outlets when you install multiple devices in a rack cabinet. Ÿ Ensure the room air temperature is below 35°C (95°F). Ÿ Do not block any air vents, usually 15 cm (6 in.
PAGE 2
Use the attached rack mounting template to locate the holes on the front and rear rack mounting flanges. Align the slide rail to the rear mounting flanges. If the front slide rail bracket does not align with the front mounting flange, slightly loosen the rail-length-adjusting screws and adjust the length of the rail. Install the slide rails, ensuring that the front and rear slide rail brackets for both slide rails are vertically aligned.
PAGE 3
Use four M4 screws per side to secure the server to the rails; then, remove the rack-support wheels and the handles and store them in a safe place. Also remove the blue thumbscrew from the left side of the server and store it in a safe place. Note: The rack-support wheels and the handles are required if you remove the server from the rack cabinet. You must also install the blue thumbscrew if you intend to remove the server from the rack cabinet and move the server to a new location.
PAGE 4
3 Slide the server fully into the rack cabinet until it locks in place. Using the handles on the free end of the cable management arm, retract the spring-loaded hinge pins ; then, rotate the handles to lock the pins in the retracted position. Slide the tab on the cable management arm into the slot in the hinge plate; then, release the hinge pins into the holes in the plate. Attach cables to the rear of the server (such as keyboard, mouse, and monitor cables if required).
PAGE 5
Slide the server into the rack cabinet until the release latches lock into place. Note: If you move the rack cabinet or install it in a vibration-prone area, insert the M6 screws ; then, install the chassis support bracket (see Step 15). If the server comes installed in the rack cabinet, the bracket also comes installed and need not be removed. Important: The chassis support bracket must be installed if you move the rack cabinet after you install the server.
PAGE 6
If you are not sure of installing the server in a rack cabinet, please contact SAMSUNG service representative.