User Manual

User’s Manual

Note

The beep sound automatically turns on after rebooting the system, even if it is

turned off.

5.1.3. Relay Off

Under System, select 3. Relay Off, and then press ENTER button. The following message

appears while Relay 1, 2 outputs on the rear panel are removed.

Note

 For detailed instructions on the relay output setup, please refer to “4.6.3. Event

Setup”(Page 44)

 The beep sound followed by events occurred is turned off if you press any

button on the panel.

5.1.4. System Update

Note

 To update the system, a USB flash drive containing the update file must be

connected to the USB port on the rear panel.

 The firmware update file must have a file name that starts with "srn", and a

filename extension ".bin".

 The firmware update file must be located in the root directory of the flash

drive. If more than one update file exists on the flash drive, the firmware

update might not install properly.

 To download the latest firmware files, please visit Support > Download Center

at www.samsungcctv.com.

Under System, Select 4. System Update, and then press Enter.

If a USB flash drive containing a firmware update file is detected, the system displays a

message prompting to see if you want to continue or stop updating, as shown in the illustration

below.

Relays are off!G

Update Firmware?

Yes: Enter No: Esc

Warning! All actions

will be stopped