User Manual

G
User’s Manual
19
Chapter 3. Installation
3.1. Installing and Connecting Product
3.1.1. Supplying Power and Operating the Product
Connect the power cord to the product as shown in the picture below.
 Once the power cord is securely connected, press the power switch in the rear panel to boot
the system.
 When the product is turned on, you can press the power switch briefly to turn off the product.
 When the system has encountered an error and you can't turn it off normally, you can press
and hold down the power switch for five seconds to force the system to shut down.
3.1.2. Configuring the Network
The following picture is an example of a network diagram using the NVR. The 3 network ports
on the product back panel are for a computer, camera, and NAS (Network attached Storage.)
Please Refer to "2.2. Back Panel" (Page 13)
The rear panel network ports can be used for devices within the same network, or in different
networks as shown in the example diagram.
Power Switch