Installation manual

CHAPTER 1. Overview of OfficeServ 7400
1-6 © SAMSUNG Electronics Co., Ltd.
1.2 Interface
This section describes the interfaces between the sub-modules of OfficeServ 7400 and the
ones between the VoIP elements.
1.2.1 Interfaces between Sub-modules
Table 1.1 Interface between Sub Modules
Categories Types Interfaces
LIM/PLIM/
PLIM2 Interface
Physical Access IEEE 802.3 10 BASE-TX, IEEE 802.3u 100 BASE-TX
Connector Type RJ-45
GPLIMT
Interface
Physical Access IEEE 802.3 10 BASE-TX, IEEE 802.3u 100 BASE-TX,
IEEE 802.3z 1000 BASE-SX/LX,
IEEE 802.3ab 1000 BASE-TX
Connector Type RJ-45, SFP (Small Form-factor Pluggable Connector)
GSIM
GSIMT
Interface
Physical Access IEEE 802.3z 1000 BASE-SX/LX,
IEEE 802.3ab 1000 BASE-TX,
IEEE 802.3 10 BASE-TX, IEEE 802.3u 100 BASE-TX
Connector Type RJ-45,SFP (Small Form-factor Pluggable Connector)
GWIMT
Interface
Physical Access IEEE 802.3z 1000 BASE-SX/LX,
IEEE 802.3 10 BASE-TX, IEEE 802.3u 100 BASE-TX,
IEEE 802.3ab 1000 BASE-TX, V.35 (T1/E1), HSSI (T3/E3)
Connector Type RJ-45,SFP, Serial 26-pin connector (non-standard cable),
Serial 50-pin connector
Access Protocol - PPPoE (PPP over Ethernet),
PPP (Point to Point Protocol)
- DHCP (Dynamic Host Configuration Protocol)
- HDLC (High-level Data Link Control)
- Frame Relay
PSTN Interface Physical Access T1, E1, FXO (Foreign Exchange Office)
Connector Type RJ-45
Access Protocol T1, E1, Loop Start
ISDN Interface Physical Access ISDN PRI
Connector Type RJ-45
Access Protocol ISDN PRI
xDSL/Cable
Modem Interface
Physical Access IEEE 802.3u 100 BASE-TX Ethernet
Connector Type RJ-45
Access Protocol PPPoE and DHCP
Voice Terminal
Interface
Analog Phone FXS (Foreign Exchange Station)
Digital Phone SAMSUNG’s Digital Phone
Wireless LAN AP
(Access Point)
802.11b