User Manual
Table Of Contents
- Important safety instructions
- Introducing your new range
- Before you begin
- Cooktop cooking
- Operating the oven
- Maintaining your appliance
- Troubleshooting
- Warranty (U.S.A)
- Warranty (CANADA)
- Instrucciones de seguridad importantes
- Introducción a su nueva estufa
- Antes de comenzar
- Cocción en cubierta
- Funcionamiento del horno
- Panel de control del horno
- Ajuste del reloj
- Cómo programar el temporizador de cocina
- Cocción por temporizador
- Inicio retardado
- Cómo encender y apagar la luz del horno
- Ajustes mínimos y máximos
- Uso de las parrillas del horno
- Hornear
- Asar a la parrilla
- Cómo usar la función de mantener temperatura
- Uso de la función Shabat
- Funciones adicionales
- Mantenimiento de su electrodoméstico
- Resolución de problemas
- Garantía limitada (Estados Unidos)
- Garantía (CANADÁ)
- Consignes de sécurité importantes
- Présentation de votre nouvelle cuisinière
- Avant de commencer
- Cuisiner sur la table de cuisson
- Utilisation du four
- Panneau de commande du four
- Réglage de l'horloge
- Réglage de la minuterie
- Cuisson minutée
- Départ différé
- Activation et désactivation de l'éclairage du four
- Réglages minimum et maximum
- Utilisation des grilles du four
- Cuisson traditionnelle
- Cuisson au gril
- Utilisation de la fonction maintien au chaud
- Utilisation de la fonction shabbat
- Fonctions complémentaires
- Entretien de votre appareil
- Dépannage
- Garantie (États-Unis)
- Garantie (CANADA)
38 English
Maintaining your appliance
Maintaining your appliance
Removing heavy, burned-on residue
1. Allow the cooktop to cool.
2. Use a single-edge razor-blade scraper
at approximately a 45° angle against
the glass surface and scrape the soil.
It will be necessary to apply pressure
to remove the residue.
3. After scraping with the razor scraper,
spread a few drops of ceramic cooktop
cleaner on the entire burned residue
area. Use the cleaning pad to remove
any remaining residue. (Do not scrape
the seal.)
4. For additional protection, after all
residue has been removed, polish the
entire surface with the cooktop cleaner
and a paper towel.
Removing metal marks and scratches
1. Be careful not to slide pots and pans across your cooktop. It will leave marks
on the cooktop surface. You can remove these marks by applying ceramic
cooktop cleaner with a cleaning pad for ceramic cooktops.
2. If pots with a thin overlay of aluminum or copper are allowed to boil dry, the
overlay may leave black discoloration on the cooktop. You should remove this
discoloration immediately or it may become permanent.
WARNING
Carefully check the bottoms of pans for roughness that may scratch the cooktop.
Cleaning the cooktop seal
To clean the seal around the edges of
the glass, lay a wet cloth on it for a
few minutes, then wipe clean with a
nonabrasive cleaner.
Potential for permanent damage to the glass surface
• Sugary spillovers (such as jellies, fudge, candy, syrups) or melted plastics can
cause pitting of the surface of your cooktop. This is not covered under the
warranty. You should clean the spill while it is still hot. Take special care when
removing hot substances. Refer to the following section.
• When using a scraper, be sure it is new and the razor blade is still sharp.
Do not use a dull or nicked blade.
Cleaning sugary spills and melted plastic
1. Turn off all surface units. Remove hot pans.
2. Wearing an oven mitt, use a single-edge razor-blade scraper to move the spill
to a cool area of the cooktop. Remove the spill with paper towels.
3. Any remaining spillover should be left until the surface of the cooktop has
cooled.
4. Don’t use the surface units again until all of the residue has been completely
removed.
NOTE
If pitting or indentations in the glass surface have already occurred, the cooktop
glass will have to be replaced. In this case, service will be necessary.
NE59M4310_AA_DG68-00881A-03_EN+MES+CFR.indb 38 2019-12-13 10:57:47