User Manual

ManualsBrandsSamsung ManualsWashing Machine: Twin Tub TypeLWT50MAS

Owner’s Instructions

BEFORE USING THE WASHER 1

CAUTIONS 1

PRECAUTIONS WHEN OPERATING 1

DESCRIPTION OF PARTS 2

CONTROL PANEL 2

WASHING PROCEDURE 3

To wash 3

Spin dry 3

Rinsing 4

Over flow rinse 4

Additional rinse 4

INSTALLATION 5

Environment 5

Changing the position of the drain hose 5

How to clean the filter 5

CLEANING THE MACHINE 5

LAUNDRY GUIDE 6

MAINTENANCE 6

TROUBLESHOOTING 6

SPECIFICATIONS

Before operating the unit, please read this manual

throughly, and retain for future reference.

SWT70B1-00685A 3/9/00 9:35 AM Page 8

Summary of content (8 pages)

PAGE 1
SWT70B1-00685A 3/9/00 9:35 AM Page 8 Owner’s Instructions Before operating the unit, please read this manual throughly, and retain for future reference.
PAGE 2
SWT70B1-00685A 3/9/00 9:35 AM Page 2 BEFORE USING THE WASHER ● Remove the cap-hose from the drain ● In case of pump drained washer, remove the cap-hose from the drain hole. hose. CAUTIONS ● Disconnect the power cord from the power supply when not in use. ● Be sure that the washer is grounded. To avoid electrical shock,use a metal pipe for the ground connection. But, don't ground the washer with gas pipes or telephone lines to avoid to dangers of explosion or lightning strike.
PAGE 3
SWT70B1-00685A 3/9/00 9:35 AM Page 3 DESCRIPTION OF PARTS SPIN DRYER LID When you open this lid while the spin basket is spinning, the spinning will be stopped by breake system. INNER LID WASH TUB LID SPIN DRYER BASKET Be sure to keep the lid closed during washing and spinning. SPIN DRYER HATCH EARTH WIRE WASH TUB STRAINER (FILTER) POWER CORD The plug’s shape may not correspond with this drawing. PULSATOR WATER DRAIN HOSE (WITHOUT PUMP) CONTROL PANEL 1.WASH TIMMER 4.
PAGE 4
SWT70B1-00685A 3/9/00 9:35 AM Page 4 WASHING PROCEDURE TO WASH 1. Before starting washing, check following; Connect the water supply hose. - Lay the drain hose down toward a sinkhole. (In case no drain pump) - Place the drain hose in sink or bath. (In case drain pump) -Connect the power cord to the power supply outlet . 2. Set the WASH SELECTOR KNOB to the desired mode. SOFT 4. Fill water in the wash tub to the ‘L’ lower water level by carefully and add the detergent. 5.
PAGE 5
SWT70B1-00685A 3/9/00 9:35 AM Page 5 RINSING 3. Set the WASH TIMER 2~3minutes. 1. Set the CYCLE SELECTOR KNOB to ‘WASH.RINSE’ WASH . RINSE WASH DRAIN RINSE CYCLE SELECTOR DRAIN WASH TIMER 4. Drain the water. Set the CYCLE SELECTOR KNOB to ‘DRAIN’. CYCLE SELECTOR (in case drain pump “WASH) DRAIN CYCLE SELECTOR 2. Supply the proper amount of water as not to overflow the top of the washing tub. 5.Repeat this cycle until drain water is clean. (2~3 cycle) OVER FLOW RINSE 1.
PAGE 6
SWT70B1-00685A 3/9/00 9:35 AM Page 6 INSTALLATION ENVIRONMENT CHANGING THE POSITION OF THE DRAIN HOSE Before attempting to change the position of the drain hose, disconnect the plug from the outlet. 1. Route the drain hose inside the machine. 2.Take out the drain hose from the opposite hole and insert the drain hose into the hose holder. Leave some space Space at least 15cm between the washer and the wall. Place the washer on a sturdy flat surface.
PAGE 7
SWT70B1-00685A 3/9/00 9:35 AM Page 7 LAUNDRY GUIDE SPIN DRY TIME WASHING TIME KINDS OF CLOTHING WASHING TIME Extremely solid heavy fabric 10 to15minutes Linen,cotton,etc. 8 to10minutes Ordinary clothes (underwear,etc) 7minutes Slightly solied synthetic fiber 2 to 5minutes 100%wool,mixed wool knitting, thin synthetic fiber with tags indicating hand washing 1~2min. TYPE OF LAUNDRY Thin(synthetic fiber) wool 3~5min. 5min. cotton thick(cotton) TIME 1min.
PAGE 8
SWT70B1-00685A 3/9/00 9:35 AM Page 9 IF YOU NEED HELP. Do not hesitate to call your local service center. They will be willing to help you. Be sure to give them your name,address,telephone number and the purpose of the call. SPECIFICATION DIMENSIONS (W x D x H)mm WATER PRESSURE WEIGHT With out pump With pump 812 x 448 x 957 0.05~0.78 MPa 0.5 ~ 8.0 kg.