Operation Manual

System Setup

English - 25

If you have already set the stations automatically, you do not need

to preset them manually.

1. With the unit in Stop mode/No Disc mode, press the MENU button.

Press the ▲▼ buttons to select Setup, then press the OK or ► button.

Press the ▲▼ buttons to select Install, then press the OK or ► button.

4. Press the ▲▼ buttons to select Manual Setup, then press the OK or

► button.

5. Press the ▲▼ buttons to select a PR (programme) you wish to edit,

delete, or swap, then press the OK or ► button. Select Edit, Delete or

Swap using the ▲▼ buttons, then press the OK or ► button.

• Edit : You can add or edit PR(programme). After change PR

informations (CH, Name, Decoder, MFT, System), select Done, then

press the OK button.

- CH : Tune the channel using ◄► buttons.

Name : Display station name automatically detected in broadcasting signal.

If not detected, you can edit name by using ▲▼◄► buttons.

- Decoder : If you set on, you can record scrambled channels using

external decoder box.

Before setting on, refer to connecting external decoder box in the

page 16.

- MFT : You can tune up the channel frequency better using ◄►

buttons.

- System : You can select broadcasting system of the receivable

channel (B/G or L/L’)

• Delete : the channel information of selected PR(programme) will be

removed.

• Swap : You can swap the channel information of two PR(programme).

For example, if you wish to swap PR2 and PR5, select swap at PR2,

then press the OK button at PR5.

Manual Setup

Done

MOVE OK

PR 01

◄ ►

Name

Decoder Off

MFT

System L/L’

01293C-VR350,355-XEB-ENG.indb 2501293C-VR350,355-XEB-ENG.indb 25 2007-03-16 오후 5:14:532007-03-16 오후 5:14:53