User Manual

10 - English
Connections
Connecting DVD-VCR
to the TV using the
RF Cable
To receive television programmes a signal must be
received from one of the following sources:
• An outdoor aerial
• An indoor aerial
• A cable television network
• A satellite receiver
1
Remove the aerial or network input cable from
the television.
2
Connect this cable to the 75Ω coaxial jack
marked on the rear of your DVD-VCR.
3
Plug the RF Cable supplied into the jack on
your DVD-VCR.
4
Plug the other end of the RF Cable into the
connector previously used for the aerial on the
television.
TV
 Make sure that both the television and the
DVD-VCR are switched off before
connecting the cables.
Note
TV
RF cable
Aerial cable
Aerial
2
3
4
Connecting DVD-VCR
to the TV using the
Audio/Video Cable
You can connect your DVD-VCR to the television
using the audio/video cable if the appropriate input is
available on the television. You thus:
• Obtain better quality sound and pictures
• Simplify the setting up procedure of your DVD-VCR
1
Connect the RF Cable.
2
Connect one end of the Audio/Video cable to
the Video output and Audio L, R output jack on
the rear of the DVD-VCR.
3
Plug the other end into the appropriate
connector on the television.
 Regardless of the type of connection chosen,
you must always connect the RF Cable
supplied. Otherwise, no picture will be visible on
the screen when the DVD-VCR is switched off.
 Make sure that both the television and the
DVD-VCR are switched off before connecting
the cables.
Note
ANT IN
Aerial
Aerial cable
RF cable