Spec Sheet

side vent kit installation instructions

Description: Exhaust kit for venting left and right side, or base

DC68-01052Y-05_EN

CHECKING THE INSTALLATION PARTS

Side Vent Kit Includes:

Vent cap Elbow Duct Front Duct Front-

Bottom

Duct Back-Left Duct Back-Right Manual

 Attached label help you recognize each duct.

WARNING

To avoid risk of electrical shock, personal injury or death; disconnect electrical power before servicing

CAUTION

Wear eye protection before performing this installation

PROCEDURE

The following instruction covers exhausting a dryer either through the left or right side of the cabinet, or through the base. It is recommended a

qualiﬁed Service Technician do the installation of this kit and dryer.

INSTALLING THE SIDE VENT KIT

1. For easier installation, removing the front assembly, tumbler and drive belt is recommended.

* Refer to service manual for disassembly and reassembly of dryer

2. Remove the knockout from either of the left or right side panel, or base. Strike it with a hammer and chisel

very close to the seam. One to three sharp blows will remove it. Do not strike the middle of the knockout.

WARNING: Wear safety glasses.

3. Remove the exhaust duct cover. (Type B only)

4. Remove the old exhaust duct from blower housing.

5. Raise guide plate to about 90 degree, using a ﬂat-blade screwdriver.

The guide plate will support the exhaust duct(f).

Type A

Type B

DV-1A_XAA-01052Y-05_EN.indd 1 2016-01-29 �� 12:37:52

PAGE 1
side vent kit installation instructions Description: Exhaust kit for venting left and right side, or base DC68-01052Y-05_EN CHECKING THE INSTALLATION PARTS Side Vent Kit Includes: Vent cap Elbow Duct Front Duct FrontBottom Duct Back-Left Duct Back-Right Manual  Attached label help you recognize each duct.
PAGE 2
FOR LEFT AND RIGHT SIDE FOR BOTTOM PLATE 6. Insert new exhaust Duct Front supplied with kit into blower housing. Rotate the duct to engage duct clip into tab extending up from base frame. 6. Assemble The Duct Front-Bottom and The Elbow. 7. Insert the assembled elbow and duct into the hole at the bottom as shown by the figure. 8. Pull the Duct Front-Bottom forwards to insert it into the Fan Housing. 7.