DJ68-00339U (EN)-0.3 8/19/08 2:25 PM Page 1 Operating Instructions VACUUM CLEANER ❈ Before ❈ Indoor operating this unit, please read the instructions carefully. use only. Register your product at www.samsung.
DJ68-00339U (EN)-0.3 8/19/08 2:25 PM Page 2 IMPORTANT SAFEGUARDS 1. Read all instructions carefully. Before switching on, make sure that the voltage of your electricity supply is the same as that indicated on the rating plate on the bottom of the cleaner. 2. WARNING: Do not use the vacuum cleaner when rug or floor is wet. Do not use to suck up water. 3. Close supervision is necessary when any appliance is used by or near children. Do not allow the vacuum cleaner to be used as a toy.
DJ68-00339U (EN)-0.3 8/19/08 2:26 PM Page 3 ▼ 1 ASSEMBLING THE CLEANER OPTION Features may vary according to model. CAUTION Please do not press the button of dust bin handle when carrying machine. For storage, park the floor nozzle.
DJ68-00339U (EN)-0.3 8/19/08 2:26 PM Page 4 2 OPERATING THE CLEANER 2-1 ON/OFF SWITCH 1) BODY CONTROL TYPE 2) ON/OFF TYPE 2-2 POWER CORD NOTE When removing the plug from the electrical outlet, grasp the plug, not the cord. 2-3 POWER-CONTROL 1) SILDE CONTROL TYPE ONLY (Optional) • SLIDE TO THE STOP POSITION Vacuum-cleaner switches off (stand by mode) • SLIDE FORWARD TO MAX Suction capacity increases smoothly up to maximum.
DJ68-00339U (EN)-0.3 8/19/08 2:26 PM Page 5 ▼ 2-4 HOW TO USE AND MAINTAIN THE ACCESSORIES Features may vary according to model. PIPE Adjust the length of the telescopic pipe by sliding the length control button located in the center of the telescopic pipe back and forth. ACCESSORY To check for blockages, separate the telescopic pipe and adjust to shorten. This allows for easier removal of waste clogging the tube. Push the accessory on to the end of the hose handle.
DJ68-00339U (EN)-0.3 OPTION OPTION 8/19/08 2:26 PM Page 6 - Detach transparent drum cover for easy cleaning. Clogs on turbine keep brush from turning, thus need to be unclogged as follows. Turbine Brush Brush for blanket For picking up pet hair and fibre on upholstery and bed linen. OPTION Remove waste Turn the lock button to matter com‘UNLOCK’, and remove pletely when inlet is blocked. waste matter. To reassemble, align the cover to the front of the main body and close.
DJ68-00339U (EN)-0.3 8/19/08 2:26 PM Page 7 3 EMPTYING THE DUST BIN 1 2 Option Once dust reaches the dust full mark, or once the dust full light is on, empty the dust bin. 3 Take the dust bin out by pressing the button. Separate the dust bin cover. CLICK 4 5 Throw away dust into the bin. 6 Close the dust bin cover.
DJ68-00339U (EN)-0.3 8/19/08 2:26 PM Page 8 4 CLEANING THE DUST PACK 4-1. WHEN TO CLEAN THE DUST PACK - If suction is noticeably reduced during cleaning, please check the dust pack as indicated below. Suction is significantly weakened during cleaning. Shaking sound of inlet stuck to the floor (soft mats, blankets, etc.) is heard. Turn the vacuum power to 'MAX' HANDLE CONTROL If the filter check indicator turns red with the inlet floating 10 cm above flat floor, clean it.
DJ68-00339U (EN)-0.3 8/19/08 2:26 PM Page 9 4-2 CLEANING THE DUST PACK 1 3 2 Remove the dust bin and dust pack as shown. 4 Remove the fixed frame of the dust pack cover. 5 Wash the sponge and the filter of the dust pack with water. 7 Remove the sponge and filter from the dust pack. 6 Let the sponge and filter dry in the shade for more than 12 hours. Put the sponge and filter into the dust pack. 8 Before reassembly, align the dust pack cover and dust pack correctly.
DJ68-00339U (EN)-0.3 8/19/08 2:26 PM Page 10 5 CLEANING THE MOTOR PROTECTION FILTER Remove the motor protection filter from the vacuum cleaner. Shake and tap the dust from it and put back in machine. Take out both the dust bin and the dust pack. 6 CLEANING THE OUTLET FILTER Press the fixed frame part at the back of the main body to remove. Pull out the HEPA Filter Dust the HEPA filter. using the tab. Put the HEPA filter into the main body until you hear a ‘click’ sound.
DJ68-00339U (EN)-0.3 8/19/08 2:26 PM Page 11 - IF YOU HAVE A PROBLEM PROBLEM Motor does not start. CAUSE REMEDY 0 No power supply. Thermal cut-out. Nozzle, suction hose or tube is blocked. Check cable, plug and socket. Leave to cool. Check for blockage and remove it. Check that the cord is not twisted or wound unevenly. Pull the cord out 2-3m and push the cord rewind button. Vacuum cleaner does not pick up dirt. Crack or hole in hose. Check hose and replace if required.
DJ68-00339U (EN)-0.3 8/19/08 2:26 PM Page 12 If you have any questions or comments relating to Samsung products, please contact the SAMSUNG customer care center. Country AUSTRALIA HONG KONG MALAYSIA SINGAPORE Customer Care Center ☎ 1300 362 603 3698-4698 1800-88-9999 1800-SAMSUNG (7267864) Web Site www.samsung.com/au www.samsung.com/hk www.samsung.com/my www.samsung.com/sg DJ68-00339U REV(0.
