User Manual

English-37
INSTALLATION07
3. Determine the position of the pipe and drain hose hole as seen in the picture and drill the hole with an inner diameter
of 65mm so that it slants slightly downwards.
• Makesuretodrillonlyoneholeafterchoosingthe
direction of the pipe.
(Unit:mm)
Model A B C D

12

36 120 81 36

18/24

33 110 110 33
Wall
< 20mm
Plastic
Anchor
4. Fix the indoor unit.
If you x the indoor unit on a wall
(1) Fix the installation plate to the wall giving attention to the weight of the indoor unit.
If you x the indoor unit on a window frame
(1) Determine the positions of the wooden uprights to be attached to the window frame.
(2) Attach the wooden uprights to the window frame giving attention to the weight of the indoor unit.
(3) Attach the installation plate to the wooden upright using tapping screws.
If you x the indoor unit on a gypsum board
(1) Use stud nder to nd out locations of the studs.
(2) Fix the plate hanger on two studs.
• Ifyoumounttheplatetoaconcretewallusingplasticanchors,makesurethatgaps
between the wall and the plate, created by projected anchor, is less than 20mm
• Searchforotherspotsiftherearelessthantwostuds,orthedistancebetweenthestudsaredierentfromthe
plate hanger.
• Fixtheinstallationplatewithoutincliningtooneside.
• Makesurethatawallcanwithstandtheweightoftheproduct.Ifyouinstalltheproductinaplacewhereitisnot
strong enough to withstand the product weight, the unit could fall and cause injury.
B
A
D
C
B
A
D
C
B
A
D
C
Pipe hole (Ø65 mm)
Pipe hole (Ø65 mm)
Assembling the hanger screw
Use 2 screws to x the indoor unit with hanger plate as shown in the picture.
Screw(M4x10)
Fixing the installation plate
1. Disassemble the cover panel as described in page 38~39.
2. Remove the Hanger plate from the indoor unit.
(1) Unscrew 2 screws that xes the Hanger plate to the indoor unit.
(2) Push the hooks (on the bottom part of the indoor unit) up to release the installation plate from the hooks that holds it.
(3) Pull the installation plate to release it completely from the indoor unit.
Screw(M4x10)
Screw
Screw
MG_GOOD_R-410A_A3050_IB&IM_EN_DB68-04540A.indd 37 9/1/2014 5:11:08 PM