User manual

© SAMSUNG Telecommunications America, L.P.
16
CHAPTER 2. OfficeServ 7200 Data Server
Installation
This chapter describes the installation and login procedures for the OfficeServ 7200 Data Server.
Installation Procedure
OfficeServ 7200 Data Server software is installed on WIM board. The software package is
composed of items described below:
Package File Description
Bootrom Package bootldr.img-vx.xx
bootldr.img-vx.xx.sum
Boot ROM program
ds-pkg-vx.xx.tar.gz Upgrade package for HTTP on the
WEB Management
app.img-vx.xx
app.img-vx.xx.sum
‘app’ partition upgrade package for
TFTP
config.img-vx.xx
config.img-vx.xx.sum
‘config’ partition upgrade package for
TFTP
kernel.img-vx.xx
kernel.img-vx.xx.sum
‘kernel’ partition upgrade package for
TFTP
log.img-vx.xx
log.img-vx.xx.sum
‘log’ partition upgrade package for
TFTP
ramdisk.img-vx.xx
ramdisk.img-vx.xx.sum
‘ramdisk’ partition upgrade package for
TFTP
flash1.img-vx.xx
flash1.img-vx.xx.sum
The first flash fusing file
Main Package
flash2.img-vx.xx
flash2.img-vx.xx.sum
The second flash fusing file
Software Package Configuration
Each package has a separate file for checking checksum, and x.xx represents the version.
Setup the environment as follows to access the Data Server.
1. Mount the WIM board on slot 1 and the LIM board on slot 2.
• In order to connect the WIM board to the LIM board through the back panel, first
place the shunt pin of JP1, 2, 3, and 4 toward the back of the WIM board, then
mount the WIM board to the back panel direction.
Home Page
Table of Contents