Service manual

Rev. 2.00

- 97 -

SRP-275

5-4 SRP-275 Whole unit Sub-assembly

5-4-1 Cover base assy

Part name Assembly procedure

① Cover base

② Frame paper control

③ PMO-roller paper/end -3ea.

④ Switch-paper near end ass’y

(Sub-assembly 5-4-2)

⑤ Screw-tapping (M2×5) -2ea.

⑥ PCB-connector sub ass’y

⑦ Screw-taptite (M3×6) -4ea.

⑧ FPC-16pin

1. Attach ② Frame paper control to ① Cover base.

2. Insert three ③ PMO-roller paper/end to ① Cover base.

3. Tighten ④ Switch-paper near end ass’y to ① Cover base with

two ⑤ Screw-tapping (M2×5).

4. Tighten ⑥ PCB-connector sub ass’y to ① Cover base with two

⑦ Screw-taptite (M3×6).

5. Insert ⑧ FPC-16pin in ⑥ PCB-connector sub ass’y.

6. Insert the connector of ④ Switch-paper near end ass’y in

connector of ⑥ PCB-connector sub ass’y.