Service manual
Rev. 2.00
- 91 -
SRP-275
5-2-5 Main-assembly E (for SMP715A type)
Part name Assembly procedure
① Frame-rotator ass’y
② Shaft-pivot -2ea.
③ Spring-rear open -2ea.
④ Ring-e hole (ø5.0) -2ea.
⑤ Frame-rear cover
⑥ Screw-taptite (M3×5)
1. Attach ① Frame-rotator ass’y on Frame-main and then insert two
② Shaft-pivot and two ③ Spring-rear open. And assemble two
④ Ring-e hole (ø5.0) to two ② Shaft-pivot.
2. Tighten ⑤ Frame-rear cover on ① Frame-rotator ass’y with ⑥
Screw-taptite (M3×5).
3. Grease two Shaft-locking, the hooks of Frame-clamshell locking
and the groove of Frame-pivot locking-L/R.
1
2
2
3
3
4
4
5
6