Service manual

Rev. 2.00

- 87 -

SRP-275

5-2 SMP715 Printer mechanism unit Main-assembly

5-2-1 Main-assembly A

Part name Assembly procedure

①

Frame-main caulking ass’y

(Sub-assembly 5-1-1)

② Label sticker

③ Plate-insulation

④ Lever-change color

⑤ Assy-gear-pulley

⑥ Gear-RE_B

⑦ Washer-plain (ø2.6) -3ea.

⑧ Solenoid

⑨ Spring-solenoid

⑩ Screw-machine (M2×2.5)

⑪ Lever-tension ass’y

(Sub-assembly 5-1-4)

1. Paste ② Label sticker and ③ Plate-insulation on ① Frame-

main caulking ass’y.

2. Grease six shafts on ① Frame-main caulking ass’y with HG-31S.

3. Insert ④ Lever-change color into Shaft-lever_CC and then

assemble ⑦ Washer-plain (ø2.6).

4. Insert ⑤ Assy-gear-pulley and ⑥ Gear-RE_B to the Shaft-gear

pulley and Shaft-R/F idle and then assemble each of ⑦ Washer-

plain (ø2.6).

5. Insert ⑨ Spring-solenoid between ⑧ Solenoid and ④ Lever-

change color and then tighten ⑧ Solenoid to ① Frame-main

caulking ass’y with ⑩ Screw-machine (M2×2.5).

6. Attach ⑪ Lever-tension ass’y on ① Frame-main caulking

ass’y.